If your Jeep Wrangler JL is lifted at least 3.5-inches, your driveshaft will most likely be damaged because the suspension is flexed to full droop. By replacing your stock shaft with this Front CV Driveshaft from Rough Country, you can eliminate full droop and avoid costly repairs. This driveshaft is specifically for Sport and Sahara 2018-2021 Jeep JL Wranglers with a Dana 30 Axle.
Driveshaft 5090.1A Features and Benefits:
- Collapsed Shaft: 36-3/8"
- Extended Shaft: 39-1/2"
- Twice as Strong as Stock Shaft
- Relocated Grease Fittings
- Eliminates Damage at Full Droop
- Included Flanges/Yokes/CV Joints
- Included Installation Hardware
- Only Works with Dana 30 (M186) Axle
- Fits 2018-2020 Jeep JL Wranglers
This driveshaft is highly recommended for JLs lifted 3.5" or more because it corrects flexing or full droop and promotes proper geometry in on-road and off-road applications. It comes with flanges, yokes and improved CV joints. The grease fittings are out of the way of your transmission pan, so you get grease to the joints and not all over the bottom of your Wrangler. Rough Country's CV drive shaft is twice as strong as your factory original, so it's less likely to be seriously damaged on or off the road. For your convenience, all the necessary installation hardware is included. Installing this driveshaft (P/N: 5090.1A) takes approximately 2-3 hours.