Sequential LED Taillight Assembly 1965-1966
Sequential LED Taillight Assembly for all 1965-1966 Mustangs.
LED lights continue to grow in popularity: and with good reason! LEDs are brighter than your factory bulbs, which makes them a better and safer choice than standard bulbs. So if you're looking for a great way to upgrade the taillights on your classic 1965-1966 Mustang, look no further than this Sequential LED Taillight Assembly that's now available from CJ Pony Parts!
Features & Benefits:
- 68 Super-Bright Red LEDs with a Polycarbonate Lens
- Sequential Operation with Selector Switch
- Switch Allows You to Select Sequential Left, Sequential Right or Sequential Function Off
- Sequential-Once Brake Attention Function
- Electronics are Epoxy-Coated and Fully Sealed
- 1157 Plug
- Solid-State Circuit Board Designed for 7.7-14.0 VDC
- Fits Driver Side or Passenger Side
- Sold Individually
This Sequential LED Taillight Assembly features 68 super-bright red LEDs with a polycarbonate lens. It has sequential operation with a selector switch that allows you to select sequential left, sequential right or sequential function off. There's also a sequential-once brake attention function! The electronic components are epoxy-coated and fully sealed to prevent damage due to water or debris. This Sequential LED Taillight Assembly has an 1157 plug and a solid-state circuit board designed for 7.7-14.0 VDC. This taillight assembly is sold individually and will fit either the driver side or passenger side of your Mustang!
Please Note: It's recommended that you upgrade to a new under-dash LED flasher. Please see CJ Pony Parts # HW2811.
Taillights are vital to any car, including your Mustang. Without them, nobody would know when you're hitting the brakes, nor would they be able to see you from behind at night. Therefore, when there's a problem with the taillights on your Mustang, you need to seek out the replacement parts for your Mustang taillights, so those lights continue to work, perhaps better than ever before!
Order a Sequential LED Taillight Assembly for your 1965-1966 Mustang from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Because you're converting a sequential, a little bit of wire will be necessary. The plug will plug right into your factory 1157 bulb. The yellow wire will have to be run to the other taillight and then a single wire run up front to your turn signal switch for proper operation.