Steeda Front Sway Bar Mount Billet Pair 2015-2020
Steeda Front Sway Bar Mount Billet Pair 2015-2019 is rated out of 5 by 3.
- High Quality Billet Aluminum
- Mounts, Bushings And Grease
- Sold As A Pair
- Made In The USA
You save 26%
Rated 4 out of 5 by navyguy1962 from Alternator in the way. I bought these for the front Sway bar on my 2015 Mustang GT. Luckily I had someone to installed these with little bit of my help. The right rear bolt sits exactly underneath the Alternator. He had to loosen the belts tension to remove the Alternator to get the bolt to tighten down. It took like over an hour once he couldn't find a tool to complete the install. Other than that they look good. I'm going this week to get the Alignment done. The car looks great. Also, it would have been easier I think with heads up on the videos that are produce. I love them, they give us knowledge about the tasks.
Date published: 2017-12-04
Rated 3 out of 5 by Clovis Clash from Difficult install but quality is solid. So, I am overall very happy with my Steeda sway bars and the resulting impact on my 2016 Ca. Special. I chose to go the extra mile with the Steeda Mounts which look great. I must say that rear set was very easy to install...however, the front brackets were very difficult! Spacing from the altenator required us to cut our traditional Allen key in order get under the altenator on the driver side. And the tightening process was very time consuming. The passenger side was slightly better but required a swivel and extension (and patience) to install. Aligning the bolts straight up and down was crucial and very difficult. If you don't align them perfectly, you can cross thread them. If you do, re-tapping with factory bolt will have to be done. Be very patient and good luck. CJ Pony was great but they can only provide moral support on this one lol.
Date published: 2016-08-18
Rated 5 out of 5 by Jastang50 from Top notch kit for the highest performance level. These are another beautiful, top quality Steeda suspension part. I installed front and back mounts with my new Steeda bars a couple years ago. Compared to the stamped steal mounts normally used, these seem far more rigid, and have urethane bushings. If you install them, make sure to use plenty of suspension grease, as there is no zerk fitting for greasing them without removing them. I saw another review mention having to cut an allen key to get the passenger side front mount installed. That's not necessary. Just remove the alternator, which is simple, and the mounts become very easy to access from the engine compartment. These mounts really are not for the casual street car, so if you're not willing to accept a little extra difficulty in installation, you may be better off just using the very good quality mounts Steeda includes with its sway bars. The rear mounts also create a close clearance situation with aftermarket exhaust systems, such as my Magnaflow Street. Not a huge problem, just something you should be aware of during installation.
Date published: 2017-04-25
Can these be used on other sway bars? Such as FRPP
No, it can ONLY be used with the Steeda Front Sway Bar (FSB20).
Date published: 2015-09-19
Complete Your Package