Electric Power Steering Conversion Kit for 1967 Mustangs with a Long Shaft Steering Box.Tired of fighting to turn your wheels in a parking lot? Sick of the vague steering feel when changing lanes at highway speed? Fix all of these steering problems with an electric power steering conversion. Now you can enjoy modern power steering in your classic car. This kit is great for Mustangs with limited engine space due to big blocks, headers, etc. The entire unit mounts inside the vehicle under the dash and will also work with rack and pinion conversions (with correct u-joint adapter for rack).
The motor includes an internal computer that measures the amount of effort applied to the steering wheel and amplifies it with the aid of the electric motor. An included potentiometer should be mounted within arms reach as it allows you to adjust the amount of assistance the motor uses. The potentiometer uses a knob that can be twisted for adjustments on the fly. For example, you can set maximum power assist while you are in a parking lot, and decrease the assist while on the highway.
- Electric power steering motor
- Electronic control box
- Firewall plate for steering shaft support with bearing
- Steering shaft with u-joints
- Wiring harness
- On/off switch
- Potentiometer to adjust the amount of steering assist
This kit will work with both manual and power steering. Ford's factory power steering is an inadequate system and notorious for fluid leaks. Electric power steering does not use any fluid and it is recommended that the factory power steering (if equipped) slave cylinder and control valve be disconnected from the power steering. Installation is rather easy with some cutting, drilling, tapping and wiring required. Although this kit is made to work with the factory steering column, modifications to the steering column are required. The long steering shaft must be cut near the steering box to install the included steering shaft. An upgraded electrical system is not required. Electrical wiring is plug and play except for a required power source and ground. All parts are located under the dash and almost completely visible. This greatly aids in the simple installation.
*MSA2 can be used to replace the power steering control valve while keeping the center link connected to the pitman arm.
Similar Mustang PartsMore Restomod Steering
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
just wondering if this system could be used on a 1958 ford 300? if not, do you have a system available at this price point that will?
I have a 67 fastback. 3 speed manual transmission without power steering. I'm trying to convirt to power steering. Is this the best way to go about it? Would this kit have everything I need? I had issue with Borgeson conviction kit. Wasn't compatible!!!
Will it go into a right hand drive ?
Hello, I have my original steering box, which seems to be a little worn. Will the new unit replace the old box?
Hi, just wondering which of your electric steering kits would suit my car. I am from Sydney Australia and own a 1967 Ford Falcon XR. I am happy to take some photos and measurements. And now much is Delivery? Thanks.
Installed in my 1967 fastback and steering wheel is too low now. Which tilt column would work best with this unit?
will this fit the 1867 mustang 6 cylinder 200
You Might Also Like
Rod & Custom Rack And Pinion/Disc Brake Conversion Kit With Tubular A-Arm System And Coilover Kit Power Steering Push Rod V8 1965-1973From: /** Note: This is used for related configurable parts to properly display price w/o regular price */?>CJ's Low Price:$3,499.99
Flaming River Rack And Pinion Power Steering Cradle Kit Without Column For Factory Spindles V8 Automatic 1965-1970/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$2,134.99
/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$876.99