Mustang JLT Cold Air Intake Kit Fenderwell Series 2 Black Textured Cobra 1996-1998
JLT Performance
Part Number: CAI2-FMC-9698
JLT Black Textured Series 2 Fenderwell Cold Air Intake Kit for all 1996-1998 Cobra Mustangs.
Using the original JLT cold air intake as a guide, JLT molded, scuplted and perfected everything until they had the best looking, fitting and performing system you can buy. The all new JLT Series 2 intake tube is 4-1/4" ID, roto molded black textured plastic for it's resistance to engine heat while keeping the intake air charge nice and cool. No metal tubing here! Gains of 14-18 RWHP are typical with this kit.
The MAF and air filter have been relocated into the fenderwell for a cooler intake charge. Works with both 80mm and 90mm MAF's, there is no need to buy additional parts when you upgrade to a 90mm MAF. Uses the factory "S" style PCV hose.
The best part about the new Series 2 intake is JLT kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a complete new kit when you reach 550-600 RWHP. Putting a Whipple, Kenne Bell or Eaton blower swap on your Cobra? Simply drill out the pre-molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF sensor electronics, add a huge 4-1/2x12 S&B Powerstack air filter and you’ve now changed your JLT Cold Air Intake into a JLT High Boost 12” Intake. Molding the MAF into the tube makes for a much smoother air flow with no couplers, reducers or separate MAF housing and can support 800+RWHP.
Includes:
- JLT black textured plastic intake tube
- Silicone coupler
- Silicone reducer
- Apron plate
- 4x6" S&B Powerstack air filter
- Silicone MAF spacer
- MAF adapter
- MAF adapter gasket
- Heavy duty clamps and all necessary hardware
Please Note: The air filter is positioned at a low level in the bumper to get the coolest air possible. While driving in the rain is not an issue, you MUST be aware of flooded streets and deep puddles.