Standard Single Exhaust Kit for all 1967 Mustangs with a 200 6-Cylinder Engine.It's time to get your Mustang back on the road and sounding like it did right off the showroom floor with a brand new exhaust kit. This standard single exhaust kit includes everything you need to replace your original system.
- Head pipe 1-3/4"
- Intermediate pipe 1-3/4" (without resonator)
- Transverse muffler (2" inlet and 1-3/4" outlet) with welded-on 1-3/4" tailpipe
- Donut gasket
- Head pipe flange
- Muffler hanger
- Exhaust U-clamps (2)
Product ReviewsWrite a review
Standard Single Exhaust Kit 200 1967 is rated out of 5 by 1.
Rated 3 out of 5 by tab1967 from Over good but some issues Overall the quality of the components is good. Muffler installed without any issues. Issues I found were 1) Length of the front and rear pipes is too long by about 2-3in. Had to cut some off the pipes to make it work. 2) U clamp supplied for the exhaust inlet is too small. Supplied 1 3/4in and should be 2in clamp to go around the muffler inlet. 3) Did not supply a 1 3/4in clamp for the engine block mounting tab. 4) Tailpipe is welded to the muffler. The tailpipe is a bit short and should be maybe 6-8in longer to extend beyond the rear cowling. 5) Muffler hanger EX35755 supplied with the kit was not required for my installation. Overall a good kit, but could be better given above issues. Customer Service does stand behind their products!
Date published: 2015-02-08
How much welding is required for the complete assembly and has the issue above been addressed?
You Might Also Like
CJ's Low Price:$98.99
CJ's Low Price:$79.99