Covercraft Taupe Car Cover Storage Bag for Use with Covercraft Car Covers.There's no sense in putting a car cover on your prized Mustang, or any other vehicle, if your car cover is just going to lay on the ground, or on a shelf, when it's not in use and collect dust, dirt or moisture! Keep your car cover clean, so you can keep your car nice and clean as well, when you're not using it with this Covercraft Taupe Car Cover Storage Bag for Use with Covercraft Car Covers.
When your car does not need to be covered, store your Covercraft car cover, or any standard car cover, in this fantastic new and effective Block-It 380 car cover storage bag. This storage bag will work with any Covercraft car cover and will contain the entire cover comfortably. Now you can easily and safely store, transport and locate your Covercraft car cover in this new Taupe Car Cover Storage Bag from Covercraft.
Pick one up today from CJ Pony Parts for yourself, or even as a gift for someone else, and never again worry about your car cover getting dirty, damaged or lost!
Similar Mustang PartsMore Car Covers & Front End Covers
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
You Might Also Like
Covercraft Car Cover WeatherShield HP Black With 50 Years Logo And Mirror Pockets Coupe/Convertible 1965-1968/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$399.99
/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$209.99
Covercraft Car Cover WeatherShield HP Black With 50 Years Logo And Mirror Pockets Fastback 1965-1968/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$399.99
CoverCraft offers their Mustang car covers in two different materials. Shown here in gray, on the left, is their Block-It 200 Series. The Block-It 200 is a high potent non-woven fabric that is USA made and designed primarily for indoor use. It is a three-layer polypropylene material for moisture resistance and can be used for limited outdoor, but again, it's designed primarily for indoor use only.
On the right, the tan cover is their Block-It 380 Series. The Block-It 380 is a high performance Kimberly-Clark material that uses two layers with a film in-between. The film is designed to keep out moisture while allowing moisture and heat to escape from underneath the cover.
These covers are designed for both indoor and outdoor use and are UV protected as well. Both the Block-It 200 Series and the Block-It 380 Series have a soft woven liner to protect your paint when installing the cover.
Shown here is a Block-It 380 Series cover on a 1968 Mustang Coupe. This cover will fit all '64 through '68 coupes and convertibles. The fitment is so specific it actually has different models available for both single and dual rearview mirrors.
All CoverCraft covers are going to have the running horse logo on the front, elastic bands for a tighter fit in the front and the rear, a grommet is included for your antenna cutout and two grommets are pre- installed for locking your cover to your vehicle. Your paint job is one of the most expensive parts of your Mustang. Make sure you protect it with a high quality cover from CoverCraft.