2-1/4" Dual Exhaust Kit for 1970 Mustangs with a 351C 4V Engine.
One of the best ways to complete a project is buying stuff in a kit. This exhaust kit has everything needed to properly install an exhaust on a 1970 Mustang with a 351 Cleveland Engine. The H-Pipe is designed to be used with factory exhaust manifolds. This factory style exhaust system features a 2-1/4" diameter exhaust that runs perfectly under the Mustang.
- Original Style H-Pipe
- Driver Side Intermediate Pipe
- Passenger Side Intermediate Pipe
- Factory Style Mufflers (2)
- Driver Side Tailpipe
- Passenger Side Tailpipe
- Exhaust Clamps (8)
- Exhaust Hanger (2)
*This exhaust kit will NOT work with staggered shocks.
Installation is a breeze with a lift and not too bad with a jack, considering it’s a 100% bolt-on installation with basic hand tools. The H-Pipe is an original style with the correct style 2-Bolt flange that are found on the original style exhaust manifolds. That runs back to two intermediate pipes that get clamped to the H-Pipe. The 2-1/4" factory style mufflers offer a sound just like when the 1970 Mustang drove off the assembly line. The tailpipes are correctly bent to follow the contour around the rear axle.
What kind of condition is your Mustang exhaust in? If it needs some repairs to get it back on the road, or you want to give your Mustang exhaust a major upgrade, check out the hundreds of 1965-1973 exhaust parts available from CJ Pony Parts. Choose from new headers, mufflers, pipes, gaskets or even complete exhaust systems, which will get your Mustang upgraded or back on the road. A new Mustang exhaust can also give your Mustang some additional performance and help make your Mustang sound awesome when rolling down the road.
Purchase a 2-1/4" Dual Exhaust Kit for 1970 Mustangs with a 351C 4V Engine from CJ Pony Parts today!
Similar Mustang PartsMore Mustang Parts
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
Why would this not work on a 69 Mustang that has a 351C 4V motor?
I just received the Dual Exhaust Kit . The kit contains two hangers. The orig. OE '70mufflers had tabs welded to them in which the hangers can be bolted . The mufflers in kit do not have tabs thus hanger can't be bolted to. How are the hangers attached?
Will this exhaust system fit a 1970 Mercury Cyclone. I have a 351 Cleveland engine in this car
Will this kit work on a 4 spd car? And are the pipes and mufflers aluminized or coated?
You Might Also Like
CJ's Low Price:$451.99
CJ's Low Price:$30.99