Ford Tooling 20" Engine Fan Shroud for 1967-1969 Mustangs with a 289, 302 or 351 Engine.This original style plastic fan shroud is constructed using original Ford Tooling. For use with any 20" stock replacement style radiator.
Similar Mustang PartsMore Fans & Fan Shrouds
Product ReviewsWrite a review
Engine Fan Shroud Ford Tooling 20" 289/302/351 1967-1969 is rated out of 5 by 7.
Rated 2 out of 5 by gag1967stang from Just doesn't quite fit will need modifications Put this on my factory 289 w/4 blade fan, this engine is 100% original but did not come with a fan shroud. this one seemed to fit real well however when re installing the fan turning it by hand the blades hit the top inside of the shroud. I removed the fan and straightened out the blades a bit that seemed to work until I hit speeds of 40+ then its back to fouling the shroud on the top. Since I really need a shroud and this one is now slightly damaged on the inside, I will probably get a shorter fan spacer and pull the fan away form the shroud and hope this works.
Date published: 2015-03-15
Rated 1 out of 5 by ryguy from Weak I purchased this product to increase the cooling capabilities of my 1968 mustang. It was to be attached to the stock 20" radiator. All connection points lined up perfectly and with the small adjustment of an aftermarket radiator overflow tank it was fairly easy. Once bolted on, I made sure the fan was not contacting the shroud and I cranked the car up. Everything seemed to be fine so I took it for a drive. When I came back a section of the top of the shroud was gone. It had been chopped by the fan. When increasing the rpms the fan shroud would flex so much that the top was sucked on top of the fan blades. A stiffer material should be used to increase rigidity. To fix my problem temporarily, I drilled two holes in top center what was left of the fan shroud and zip tied it to the radiator.
Date published: 2015-05-25
Rated 5 out of 5 by Nealey10 from Great product Excellent shroud. Fit well and needed just a little adjustment. Really helped with cooling on my 68 Mustang.
Date published: 2015-08-17
Rated 1 out of 5 by HPDave from Doesn't fit correctly Slowly fixing up my 67. Have original 289 in it. Did not fit. Fan ate it up even after adjustments. ended up just taking it off. Waste of money. The original fan shrouds were two-piece shrouds.
Date published: 2015-04-10
Rated 5 out of 5 by Cwire from Fits perfectly! Great product, also fits very snug to keep that air go into the radiator. You won't be disappointed with this purchase from Cj pony parts!
Date published: 2015-01-08
Rated 5 out of 5 by mhp1067 from Fits Perfect Has this installed on my '67 289-2V convertible. Piece of cake!
Date published: 2015-03-27
Rated 5 out of 5 by Snake from 68 Cougar Excellent fit, worked very nicely in my 68 Cougar.
Date published: 2015-03-13