Motor Mount Kit for all 1967-1970 Mustangs equipped with a 390 or 428 big block engine.Kit Includes:
-Pair of engine side brackets
-Pair of frame side brackets
*Mounting hardware not included.
Product ReviewsWrite a review
Motor Mount Kit 390 / 428 1967-1970 is rated out of 5 by 1.
Rated 3 out of 5 by Sprint69 from Good product but requires modifications What is shown in the picture will work but the set i got had to be modified. The engine frame mounts had 2 different widths on the bottom lip. The passenger was about 1 1/2" which allows the actual motor mount slot to slip over this. On the driver side the lip was 2" wide which is about 1/4" wider than the motor mount slot. For this i am referencing the area along the top or bottom of the metal portion of the motor mount that meets the engine frame mount. I also had to grind the front edge of the motor mount where it meets the engine frame mount for alignment of the bolt that attaches the 2 mounts together. There is a flange or lip in the engine frame mount where it folds over for a small bracket that mounts to the front side of the engine frame mount. This is the portion that attaches to the shock tower. I am not sure if i just got a bad set or if all of them are produced this way. They do work but require some grinding. I looked at several used sets on ebay after the lip / flange would not rest properly on the actual motor mount. The flange or lip on the bottom of the engine frame mount is the same width on each side of which appears to be about 1 1/2" wide.
Date published: 2015-12-17
1967 mustang 302 will a 390ci fit
If i am not mistaken, on a 1967 ONLY, these will work with a small block. Not sure if the question is aimed at the mounts or if a FE block motor will fit in a 1967 Mustang.
Date published: 2015-11-28