Scott Drake Standard Wheel Horn Ring for 1965-1966 Mustangs Using an Alternator.Excellent concours reproduction made by Scott Drake. Die cast construction features acrylic plastic center emblem, chrome plated main assembly and painted recesses. Fits alternator Mustangs.
*If your 1965 Mustang uses a generator, use part number HR1.
Product ReviewsWrite a review
Will this fit a factory 1967 mustang steering wheel to get rid of the ugly horn button?
Because of the shape of this horn ring I'm concerned about which steering wheel to pick up - can you give some examples of which steering wheels will work with this horn ring?
You Might Also Like
Regular Price: $177.99
Special Price: $124.59
Regular Price: $14.99
Special Price: $10.49
Regular Price: $2.99
Special Price: $2.09
Our black plastic steering wheel is an exact reproduction of the original. The horn ring from Scott Drake we're going with has all the detail we've come to expect from their products; the correct paint in the circles, as well as the highly detailed paint in the Ford Mustang as well as the correct logo.
For this installation you'll need a steering wheel puller, 1/2-inch ratchet, short extension, 15/16th socket, 3/8 ratchet, 1/2-inch socket and an adjustable wrench.
See our original horn ring is in really rough shape. All the chrome's off the top here. It's flaking down here. The paint is falling off. Our wheel has this cheap plastic cover on it to cover up all the cracks. It's definitely time for an upgrade.
The first step is going to be to remove our original horn ring. ou'll disconnect your battery before you get started that way the horn's not going off as you remove it. To remove it you simply press in and turn. You'll want to make sure you grab the spring; you'll want to use that with our new pieces.
Now, you're going to remove the bolt that holds the wheel to the column. You'll want to hold the wheel and the wrench kind of at the same time to get it to come off.
At this point, you're most likely going to need a steering wheel puller. Sometimes the wheel may come off. Most times you'll need the puller. Ours isn't budging. We're going to use our steering wheel puller to get it out. We'll start by lining up the plate here. We'll put our screws through. These don't have to be threaded in all the way. You just want them in far enough to get a good grip on the wheel so we can pull it out.
Now we're ready to get our new steering wheel. You want to make sure that you have the wheel as centered as possible when you remove it and install the new one the same way. I'll line up our new wheel, press it down on the spring and put our retaining bolt back on. Now we'll tighten the retaining nut down and again hold the wheel while you turn the wrench. The new horn ring comes ready to install. You line up the three tabs from the retainer with these three openings here and make sure you install the original spring first. Push it flat and you'll feel it pop in, applying pressure, just turn and it'll lock in to place.
Now that our horn ring is installed, we will reconnect our battery to make sure our horn works; (honk honk) and check if the turn-signals cancel and our installation is finished.
Our new horn ring and steering wheel really freshened up the look of our interior. Installation should only take you about half an hour. You'll be back on the road in no time.