Splash Shield Kit for 1967-1968 Mustangs.Save time and money with this great splash shield kit! Comes with everything you need to install new splash shields to the front and rear, driver and passenger side of your Mustang.
These reproduction splash shields are made from stamped metal with stapled rubber shields for water protection.
- Pair of front splash shields
- Pair of rear splash shields
- Mounting hardware (16)
Product ReviewsWrite a review
Splash Shield Kit 1967-1968 is rated out of 5 by 6.
Rated 4 out of 5 by Jeez from Good but not easy to install I had to modify the product to install. Trim 1/4" off the end, trim the quarter pillar bracket area and drill the mounting holes. Modifications were all on the rear splash shiel, both sides. The front splash shields bolted directly to the Dynacorn fenders I purchased. Fronts were a great fit. Once installed, fenders mounted great with good gaps. Good product just be prepared for minor modification to the rear shields.
Date published: 2015-11-02
Rated 5 out of 5 by 71redrino from Well built product Bought this a couple weeks ago for my 67 coupe, other than having to bend the top tab a little and grind a little out of corner where it meets the firewall over hang it fit perfect and all holes lined up very well manufactured product
Date published: 2016-04-04
Rated 5 out of 5 by dialh from Fitment was very good. These shields saved me a ton of time over making up a set from parts. The rubber is also better quality than the repop rubber pieces.
Date published: 2015-11-23
Rated 5 out of 5 by fireman3 from NIce fit bought the kit to replace the rusted out ones on my mustang. Bolted right in with no issues
Date published: 2015-08-03
Rated 5 out of 5 by Djbde2016 from Fit right in Bought complete set, they went right in. fit was as good as oringinals
Date published: 2016-03-12
Rated 5 out of 5 by orgas_moose01 from well made very nice set and complete well made fit and finish very good
Date published: 2016-03-26
How do you install front rear splash shields on 66 Mustang. Behind front tire.
Remove the front wheels to gain access to the retaining screws, open the hood and there will be one screw at the rear corner where the fender and the cowl meet.
Date published: 2016-04-28
Are this parts (CJ P/N: M256K) similar with cougar 1967 too?
The vendor has not provided any information regarding cross-fitments of this part to any other model then what is listed.
Date published: 2016-03-22
hi is this the right part for the mustang 1968 fastback??? and do you ship to Malta?
By Bill Tumas: We’re here with a splash shield kit fitting all 1967 and 1968 Mustangs. Splash shields are going to mount in your front wheel wells in front and back of your front tire. Our kit includes both of the rear splash shields, as well as the front splash shields, including both the metal plates, as well as the rubber seals, and a complete set of screws for installation. Our splash shield kit gives you everything you need for installation, although the splash shield, as well as the installation hardware, which are sold separately.