Classic Tube Brake Line Kit Complete Power Drum Mustang 6-Cylinder 1967 Built After 2/1967

Are you looking to restore the brake system on your 1967 Mustang? If so, you might be interested in replacing all the brake lines at the same time with this Complete Brake Line Kit from Classic Tube. The Classic Tube Complete Brake Line Kit is a direct replacement for 1967 Mustangs with a 6-Cylinder Engine and Power Drum Brakes Built After February 1967.

Kit Includes:
- Master Cylinder Lines
- Driver Side Front Brake Line
- Passenger Side Front Brake Line
- Intermediate Brake Line
- Rear Brake Lines

 Material Options:
- Original Steel Brake Lines
- Stainless Steel Brake Lines

The Classic Tube Complete Brake Line Kit comes with every brake line that is needed to fully restore the brake plumbing on your 1967 6-Cylinder Mustang. Since these Brake Lines are identical to the original brake lines the correct bends contour the body panels that the brake lines attach to.

When the complete brake line kit is constructed all the correct fittings are installed for an easy installation. On each end of the Brake Lines double flares are used when flaring the end of the brake lines. The Double Flare provides a tight seal when the brake lines are connected.

Tech Tips:
- Original steel lines will give your Mustang a classic factory-original look, while the more modern stainless steel lines will rust less than the original steel.
- If you are doing a disc brake conversion on a drum brake car, it is recommended you order brake lines for your car’s original configurations. Many disc brake conversion kits are made to work with the original drum brake lines and may not match up to factory disc brake lines.