Flowmaster Cat-Back Exhaust Kit American Thunder 2-1/2” With 2-1/2” Stainless Steel Tips GT/Cobra 1994-1997
Flowmaster 2-1/2" American Thunder Cat-Back Exhaust System with 2-1/2" Stainless Steel Tips for 1994, 1995, 1996, 1997 and 1998 GT and Cobra Mustangs.
Are you a person that wants an aggressive sounding Mustang? If so you might be interested in this 2-1/2" American Thunder Cat-Back Exhaust System with 2-1/2" Stainless Steel Tips from Flowmaster. This Flowmaster Exhaust System is designed to replace your restrictive original exhaust and will replace it with a mandrel-bent performance exhaust system. This American Thunder Exhaust System is a direct replacement for any 1994-1997 5.0L or 4.6L V8 Engine.
- Mandrel-Bent 16 Gauge Tubing
- Moderate Exterior Exhaust Note
- Dyno Tuned for Added Performance
- Super 44 Series Mufflers
This American Thunder exhaust system has been designed with the latest exhaust technology available. Through this technology, you will experience improvements in acceleration, passing power, and fuel mileage. The key to these performance improvements is the use of mandrel-bent tubing. The tubing allows for superior exhaust gas flow, while aluminized steel construction has been utilized for its corrosion-resistant qualities.
Flowmaster is one of the most popular exhaust manufacturers for Mustangs. In general, aftermarket exhausts can help you get the best experience out of your car. Flowmaster takes it to the next levels with products like dual exhaust systems for every Mustang generation even the classics. At CJ Pony Parts, we’re proud to offer Flowmaster exhausts to customers looking for that classic muscle car roar and the horsepower that goes with it.
Purchase a new Flowmaster 2-1/2" American Thunder Cat-Back Exhaust System with 2-1/2" Stainless Steel Tips for your 1994, 1995, 1996, 1997 or 1998 GT or Cobra Mustang from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Intermediate skill is required for this installation.
Alex: Thank you for having me Bill. How are you doing today?
Bill: I'm doing good. We all know the two chamber Flowmaster. If you had a Fox Body back in the day you had some Flowmasters on it. But what else can you tell us about your company?
Alex: Well, Flowmaster is an aftermarket performance exhaust manufacturer, Bill, that started off on the racetracks. Ray Flugger, the founder of the company, designed mufflers for racers that were being hammered for excessive noise limits. Flowmaster presents that opportunity where you're able to reduce those dB levels without having to hurt or kill performance. Flowmaster is also one of the most significant speed parts of all time where we are actually an innovative product different from the standard that's out there.
Bill: The two chamber Flowmaster that was the original product he was selling out of a suitcase.
Alex: The 40 Series, except with some slight modifications on the case itself. Back then it was a square case and now it's more of a round oval.
Bill: The other mufflers you have here, what can you tell me about them?
Alex: Here we have a 50 Series Delta Flow to the far right, which is a three chamber design, a little more subdued, a little mellower for those that are looking for less interior resonance. In the middle here we've got a Super 40, which is a two chamber design, a little thicker, a little wider, which is set up to handle higher output applications. To the far left we've got a Super 44, which is the latest and greatest two chamber design that Flowmaster has released in recent years.
Bill: Is that still based off of the original design?
Alex: That is correct.
Bill: I know Flowmaster has a lot of kits available for the 2005 and newer Mustangs. What can you tell me about these two kits you brought with you today?
Alex: Well, Bill here we've got a Force II exhaust system from Flowmaster. It's a direct bolt on axle back 409 stainless steel with a limited lifetime warranty, fully constructed here in the U.S. It's got the rolled edge stainless steel tip with the nice four inch diameter. All of the hardware, everything you need, is included within the kit so you don't have to buy any additional accessories.
This would probably take you an hour and a half to install out of your own garage on a weekend. Very subdued, very mellow kind of tone, something designed for someone who's looking for more of a performance aspect with a little bit of rumble, nothing too wild, nothing too crazy.
Over here on the right we've got the Outlaw System. The Outlaw is very noticeable, very aggressive. It's the 'hear me from a mile away' type of sound, something I would only recommend to those who are fully aware of what they're getting. It utilizes an Outlaw race muffler, basically a muffler that was designed for race applications that are required to run mufflers without a specific dB limit. Again, I only recommend it to those that are looking for the aggressive tone from Flowmaster. It is fully built out of stainless steel, lifetime warranty as well.
Bill: The Outlaw is available for '05 and up for both the 5.0 liter and the 4.6 liter cars?
Alex: That is correct.
Bill: We know Flowmaster that has systems that fit all year Mustangs, but I heard you guys are getting in other parts of the exhaust as well?
Alex: That's right, Bill. We actually just released a full line of stainless steel headers, ceramic coated, very high end piece. They look great. It'll compliment the rest of your exhaust components. We also just released a full line of catalytic converters, both 49 state and carb certified.
Bill: If you're looking for that classic Flowmaster sound, it doesn't matter what year your car is, Flowmaster has a system that will fit your Mustang.