Ford Racing Control Pack Coyote Gen 3 w/ 10R80 Transmission Mustang 21-23

This Ford Racing Control Pack will get your custom engine swap running properly in your vehicle that is equipped with a Gen 3 5.0L Coyote and 2021+ 10R80 Automatic Transmission. The Ford Racing Gen 3 Coyote Control Pack will not only replace a factory wiring harness but is designed for custom vehicle builds with a 2021+ 10r80 automatic transmission. The Ford Racing Gen 3 Coyote Control Pack comes a with a Ford Racing Calibrated PCM with the latest 2021+ 10r80 automatic transmission calibration. The Ford Racing Gen 3 Coyote Control Pack features an OBD-II diagnostic port for troubleshooting and has an electronic throttle control that will eliminate the need of routing a custom throttle cable. The Ford Racing Gen 3 Coyote Control Pack comes with Mustang GT airbox with inlet tube and MAF (Mass Air Flow) sensor. The Ford Racing Gen 3 Coyote Control Pack has the necessary upper and lower radiator hoses and HEGO (Heated Exhaust Gas Oxygen) sensors for ease of install.

Features and Benefits:
- PCM with Ford Racing calibration with 10R80 Transmission
- Electronic Throttle Control accelerator pedal
- Eliminating Throttle Cable Routing Problems
- Unique control pack harness is designed for custom vehicle builds
- OBD-II Diagnostic Port
- Power Distribution Module
- Mustang GT Airbox
- Mustang GT Air inlet tube
- OE MAF sensor
- Upper and Lower Radiator Hoses
- HEGO sensors

Please Note: This Control Pack is designed for use with a 2021+ 10r80 Transmission. NOT for use with any F150 engines.

Tech Tip: The Ford Racing calibration requires return type fuel system, will NOT work with return-less fuel system. Installation of this PCM into a 2018-2023 Mustang GT will result in a no-start condition.