JLT Cold Air Intake Kit Fenderwell Series 2 Black Textured Mach 1 2003-2004
JLT Black Textured Series 2 Fenderwell Cold Air Intake Kit for all 2003-2004 Mach 1 Mustangs.
Using the original JLT cold air intake as a guide, JLT molded, sculpted and perfected everything until they had the best looking, fitting and performing system you can buy. The all new JLT Series 2 intake tube is 4-1/4" ID, roto molded black textured plastic for its resistance to engine heat while keeping the intake air charge nice and cool. No metal tubing here! Gains of 14-20 RWHP are typical with this kit.
The MAF and air filter have been relocated into the fenderwell for a cooler intake charge. Works with both 80mm and 90mm MAF's, there is no need to buy additional parts when you upgrade to a 90mm MAF. Uses the factory "S" style PCV hose.
The best part about the Series 2 intake is JLT kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a complete new kit when you reach 550-600 RWHP. Putting a Whipple, Kenne Bell or Eaton blower on your Mach 1? Simply drill out the pre-molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF sensor electronics, add a huge 4-1/2x12 Powerstack air filter and you've now changed your JLT Cold Air Intake into a JLT High Boost 12" Intake. Molding the MAF into the tube makes for a much smoother air flow with no couplers, reducers or separate MAF housing and can support 800+RWHP.
- Textured Black Plastic Finish
- Silicone Coupler
- Silicone Reducer
- Apron Plate
- Powerstack Air Filter
- Silicone MAF Spacer
- MAF Adapter
- MAF Adapter Gasket
- Heavy Duty Clamps
- Necessary Mounting Hardware
Please Note: This JLT Cold Air intake is CARB Approved (D-761)
*Stock Shaker system is NOT used with this kit.
*Will NOT fit with most strut tower braces.
If you're looking for some of the best cold air intakes and performance parts for your Mustang, go no further than CJ Pony Parts' selection of parts from JLT Performance. With more than several 2011-2014 Mustang parts available, you can find exactly the cold air intake you need for your performance Mustang-just check out the selection of JLT Performance parts from CJ Pony Parts today!
Purchase a new JLT Black Textured Series 2 Fenderwell Cold Air Intake Kit for your 2003-2004 Mach 1 Mustang from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Intermediate skill is required for this installation.