Painless Performance Pro Series 23 Circuit Harness Bulkhead Style Chevrolet C10 1960-1987

The Painless Pro Series (10406) makes wiring your C10 restomod or custom an easier process! Ample length is provided for each circuit, providing you the freedom to route and hide your wiring how you choose. Included are over 25 GM factory style connectors, allowing you to turn the Pro Series harness into a direct fit harness for your application. LED ATC bladed fuses get you away from the old hard-to-find glass fuses, and will light up if blown, to make troubleshooting a painless task.

This Kit Includes:
· GM washer pump connector
· Courtesy light sockets
· GM headlight switch connector
· GM dimmer switch connector
· GM brake switch connector
· GM turn signal switch flat connectors
· Neutral Safety Switch connector (column mounted or factory floor shifter mounted)
· Reverse Switch connector (column mounted or factory floor shifter mounted)
· Braided ground straps (for body and core support to frame grounding,
· Alternator bag kit with terminals, splices, resistor, diode to connect the alternator. (1) Connector for GM 10si alternator
· Assortment of insulated and non-insulated splices, ring terminals, heat shrink, grommets, cable ties, and cable tie clips.

This harness features a GM Bulkhead style firewall pass through with the fuse block mounted inside the vehicle on the firewall. The wires are pre-terminated using Packard factory crimping machines and utilize a bulkhead to mount to and pass through the firewall, keeping your wiring safe and protected and allowing you to easily disconnect the firewall forward wiring without having to remove wiring from each individual component. Each wire is extra length with up to 20’ of length to the front and over 25’ to the rear providing ample length for mounting your fuse block and freedom to route the wiring how you choose.

Vehicle Fitment:
1960-1987 Chevrolet C10