Rigid Industries LED Flood Light Dually PRO Pair

Today on CJ Off-Road, we're gonna add some LED lights to our F-150 Raptor to make it see a whole lot better when backing up at night. When backing up at night, it can be really difficult to see even if you have a back-up camera like with our Raptor, so today we're gonna make it a lot easier to see by installing these Rigid Industries Dually LED Flood Lights in the back of our bumper on our 2017 F-150 Raptor. These LED flood lights were made in the USA with a cast aluminum housing and four super bright LEDs putting out 3,168 lumens, protected by a polycarbonate lens. They put out a nice flood light pattern, which will make them perfect for reverse lights, so today we're gonna install them in our rear bumper on our 2017 F-150 Raptor.

These Rigid Industries LED Flood Lights can be installed pretty much anywhere on any vehicle, but we're gonna be putting them in the rear bumper of our truck because they do have slots right here for these cube lights and a bracket. So all we have to do is feed the wire through and then get the bolt on this bracket onto the bracket that's on the bumper. Get the bolt through the bracket, and then you can install your washer and nut. All right, we can now wire it up. We have the LEDs installed into the bumper, they're looking pretty good. Now it's time to wire it up. We're gonna use the wiring harness that came with the kit. We're gonna hook up to the two cubes and then run the harness all the way along the frame, into the engine bay. Just simply plug in the connectors and then run the harness along the frame.

Okay, we have the wiring harness running up right here. We had to extend a little bit because it wasn't quite long enough, and we used crimp connectors and connected it to this wire right here. This is the violet and orange wire for switch number three. We have the ground wire right here as well and we're gonna connect it right here to this grounding point. Okay, both wires are now connected. Now we can see how the lights look.

All right, let's see how they look. Okay, we got our Rigid Dually LED Lights installed on the rear bumper of our Raptor. They're looking pretty awesome, and they're really gonna help out with backing up and hooking up a trailer. Installation really wasn't that bad either. It should take you about less than two hours. Before you know it, you'll be heading off-road.