Rugged Ridge X-Clamp Textured Black With 3-1/2" Round LED Light For 1-1/4"-2" Round Bar
Rugged Ridge Textured Black X-Clamp with a 3-1/2" Round LED Light for 1-1/4" to 2" Round Bars.
California Residents: Proposition 65 Warning
This Rugged Ridge X-Clamp is made of die-cast aluminum with a nice textured black powder coat finish. To fit 1-1/4" to 2" roll bars, to mount cameras, lights, and antennas. And, it comes with a super bright round LED light, rated at 1040 lumens. So, today we're going to install it on our 2016 Jeep Wrangler.
The first thing we're going to do, is remove all four bolts from this X-Clamp so we can get it onto the bumper bar that's on the Jeep. As you can see, this kit comes with three different bolt sizes. The long ones are already installed in the X. There's a medium and a short bolt. We actually need the mediums to work with our bumper bar. So, we're going to take these out and put the medium bolt in.
With all the bolts removed you can put the X-Clamp over the bumper bar. Then install the medium bolts. Then tighten the bolts using a 5mm hex key. Then grab the bracket and mount it to the clamp. You can actually mount this in four different positions. Pick the location that you want. Then install the bolt.
You can now use the provided hardware to install the light to the clamp. Then tighten it down using a 13mm socket and wrench. Position it to your liking. Then your installation's finished.
A Rugged Ridge X-Clamp and LED light is installed. It allowed us to add more lighting to our bumper bar. Installation's not too bad. It should only take about 15 to 20 minutes, and before you know it you'll be heading off road.
This product will fit the following Bronco years:
This product will fit the following F-150 years:
This product will fit the following Gladiator years:
This product will fit the following Wrangler years: