Back Up Light Kit 1965-1966

CJ's Part Number: BLK1
MSRP: $75.92

Regular Price: $73.99

Special Price: $51.79

1418947200 3119
Earn 73 RPM Points What's this?
1418947200 1420070400
On Sale: End of Year Blowout!
BLK1 BLK1_1 BLK1_2 BLK1_3 BLK1_4 BLK1_5

Product Description

Back Up Light Kit for 1965-1966 Mustangs.

Replacing the rear valance and need some new back up lights to finish it off? This is the perfect reproduction chrome back up light kit to save you money and time.

Kit Includes:
2 - Lenses
2 - Lens Gaskets
2 - Light Bodies
2 - Body Gaskets
2 - Bulbs

Similar Mustang Parts

similar mustang parts More Mustang Backup Lights  

Installation Instructions


Difficulty: Easy

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Very Sharp
My original b/u lights were shot to hell so I decided to just buy this kit. It looks absolutely beautiful. I already was replacing the gas tank, so it was really easy to get this kit installed in less than an hour. The light to body black gasket is a little tricky but I found it super easy to put on when I used a tiny allen wrench to follow it around the light and the rubber laid in to place. My only real complaint is that the ground wire needs to be a little bit longer. There is no slack whatsoever to speak of. But overall a beautiful kit.
Diggler September 24, 2014
Back up light kit
Kit was missing body gaskets, but had extra pair of lens seals. Called and they are shipping a pair of correct gaskets.
Ron September 8, 2013
Great Look
Looks great but yes, the bulbs are a little difficult to install but other than that I would buy them again.
Sambo June 5, 2013
Installation of Back Up Light Kit for 65 Coupe w/C4 Trans
Considering these are after market back up lenses I was pretty pleased with the overall quality. My lenses came completely assembled. The bulbs were even installed. The installation took about 2 hours per light. My Mustang didn't come equipped with B/U lights, so I had to do some cutting and spend some time under the dash locating the wiring from the neutral safety switch. The only negative issue was the size of the rubber grommet that was molded on the wiring. The grommet is about a 1/4 inch too small to fit snug in the factory cut out on the inner rear lower portion of the quarter panel. I had to add some clear caulk to ensure a water tight fit. Overall, very pleased!
Ron April 17, 2011
to hard to put the bulbs in
The spring is too hard and fixture are incorrect and it is next to impossible to put the bulbs in.
scott March 6, 2011
5 Results

You Might Also Like