Ford Racing Control Pack for use with the 2011-2014 4V 5.0L Crate Engine and a Manual Transmission.
Take the complexity and mystery out of wiring a 2011-2014 5.0L 4V engine! This control pack is designed to run the new M-6007-M50 5.0L 4V crate engine. Unique controls pack harness replaces stock body harness and is designed for street rod installation.
-PCM with Ford Racing calibration
-Electronic Throttle Control accelerator pedal (eliminates throttle cable routing problems)
-OBD-II diagnostic port to assist in vehicle calibration upload and problem diagnosis
-Unique downsized power distribution module
-MAF sensor with bolts
*PCM with Ford Racing calibration requires return type fuel system, will not work with returnless fuel system.
*Installation of this PCM in a 2011-2014 Mustang GT will result in a no-start condition.
Similar Mustang PartsMore Mustang Crate Engines & Cylinder Blocks
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
To replace 65 mustang engine with a coyote crate and control pack, what other parts are needed?
Is there a similar kit for a 4.6l 3v engine??
so if I need an oem harness to make this work were would I get an oem harness
so i still need the oem engine harness???
the video says the control pack come with almost everything needed to install the coyote engine into what ever. MY COYOTE ENGINE HAS NO HARNESS ATTACHED TO IT. DOES THIS COME WITH EVERYTHING I NEED TO PLUG INTO ALL THE ENGINE SENSORS AND EVERYTHING.