Fuel Tank Kit 1971-1973

CJ's Part Number: FTK4
MSRP: $196.95
CJ's Low Price:
1419552000 15755
Earn 191 RPM Points What's this?

Product Description

Fuel tank kit for all 1971-1973 Mustangs.

With the price of gas there is no better time to replace your rusted out stock tank. This kit is a direct replacement for the stock fuel tank with the correct 20 gallon capacity. Coated to prevent rust and corrosion. Measures 30-3/4" x 22" x 9-3/4".

Kit Includes:
- Fuel Tank
- Fuel Sending Unit with Gasket
- Locking Ring
- Filler Pipe Gasket
- 71-3 Gas Filler Pipe Seal in Trunk

Save time and money with this kit. Filler pie sold separately.

Similar Mustang Parts

similar mustang parts More Mustang Fuel Tank Kits  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Easy installation all the hardware was spot on all in all a good product.
Donnie Ensey October 10, 2014
Good Kit
This was a good kit. Installation was simple, and all the parts, except the vent valve in the top, were included. The only thing I did not like were the seals for the sending unit. Given the location of the sending unit, it was difficult to get the seal to lay in correctly. Otherwise, good kit, easy install.
DBWest September 9, 2014
great product
Great product, I've used after market kits before, being in the automotive field this had to be by far the best fitting, fastest shipping, all parts needed kit. Good job guys!
great product August 21, 2014
73 Mustang Fuel Tank Kit
I installed this kit into my 73 Mustang Fastback. My old tank had seen better days. This is a good kit and I found if fairly simple to make the swap. Make sure you drive your car and empty the old fuel tank as much as possible till gauge reads as close to E as possible. (You will thank me for this tip). I would also recommend you replace the old rubber fuel lines while the tank is empty. Buy some additional 3/8 rubber fuel line about 3.5 feet should do the job. You need about 7 or 8 inches of fuel line for the tank to metal fuel line and then 2.5 feet to replace the fuel tank vent line (Top of tank). You will use the old tank retaining rings for the vent and the float if you are careful when you remove them (Careful no sparks). Be sure not to damage the old rings when you remove them from the tank. You will also need an additional vent gasket that this 'kit did not include'. Be sure to check the old vent is clear and you can blow air through it and its not blocked. I tried to blow some air throu
Idaho73FastBack August 11, 2011
4 Results

You Might Also Like