Hood To Cowl Seal for 1965-1966 Mustangs.Eliminate water and debris from getting in to the engine bay with a new hood to cowl seal. This seal extends the length of the backside of the hood, where it meets and attaches to the cowl.
Clips installed in the seal for installation.
Similar Mustang PartsMore Mustang Fastback Weatherstrip
I agree with Charles. Most of the clips broke off trying to put it on. I may try weatherstrip adhesive to keep it up there.
The rubber strip is a quality product but the pre installed clips are very flimsy and I stopped the install after breaking two of them. The tangs that hold the clip to the rubber are not strong enough. I will be sending this back
Noticed this was missing from my car, ordered this and the brackets (with included screws). The only tough part of the install is there are no pre-drilled holes in the weatherstrip and of course the hood gets in the way of your screwdriver. Looks good after installed; if my car is ever in the rain this should help keep the water out of the engine compartment. Good product.
You Might Also Like