Mustang Back Up Light Kit (1967-1968) Installation Instructions

• 
• 
• 
• 

Back Up Light Kit for 1967-1968 Mustangs

This Back Up Light Kit fits every 1967-1968 Mustang.

As Mustang owners rehabilitate the electrical systems and taillights of their 1967-1968 cars, the back up lights are often the finishing touches. This kit includes everything necessary to replace both back up lights, and save a lot of money and time doing so.

This Install Also Applies To:

• Mustang Back Up Light Kit 1965-1966
• Mustang Back Up Light Assembly 1967-1970
• Mustang Back Up Light Assembly 1965-1966

Tools Required:

• 3/8 inch Socket and Ratchet
• Extension and Universal Swivel Recommended

Install Difficulty:

• 
• Easy Project

1. To starting installing your new Mustang Back Up Light Kit, remove the old back up lights. To do so, unplug the two pronged connectors on the back of each back up light assembly from the wiring harness. Then, remove the nuts that hold the back up light assemblies (two per lighting assembly) from the inside of the rear valance. This may be a challenge if your Mustang is as rusted and corroded as mine. Note, the two screws on the front of the light assembly do not have to be removed. They retain the lens for easy replacement of the bulb.

2. Open the new back up lights and inventory all parts. There are screw posts on the back of the light enclosures, but the kit doesn’t come with nuts. If the old ones aren't salvageable, you might need to order new Mustang back up light and parking light nuts.

3. If desired, you can test the new Mustang back up lights with 12VDC test voltage.

4. Simply install the new lights by tightening the two nuts per assembly.

5. Fish the two conductor pigtails through the openings beneath the trunk and secure the rubber grommets through the openings.

6. Reattach the plugs to the Mustang tail light wiring harness.

7. Enjoy your new Mustang Back Up Light Kit.