Set of 1/4" Power Steering Control Valve Tube Seats for 1965, 1966 and 1967 Mustangs with Factory Power Steering Built Before June 19th, 1967.An important component of any properly functioning power steering control valve, this set of four direct replacement 1/4" Power Steering Control Valve Tube Seats securely seal and hold the power steering hoses in place on to the power steering control valve. Each tube seat is designed to OE specifications for a direct fit on your 1965, 1966 or 1967 Mustang with factory power steering, built before June 19th, 1967.
Most power steering control valves have had multiple hoses reinstalled and replaced over the years without ever having the tube seats replaced. This results in the tube seats having several different ridges cut into their surface and may no longer seal properly, even to a new hose. A heavily damaged tube seat may even damage the flare surface of a new hose, causing it to not seal properly even after a new tube seat is installed.
If it's time to replace the original power steering control valve tube seats on your 1965, 1966 or 1967 Mustang with factory power steering, built before June 19th, 1967, this set of four reproduction 1/4" Power Steering Control Valve Tube Seats are just what you need!
Please Note: 1967 Mustangs with factory power steering, built after June 19th, were equipped with 5/16" Power Steering Control Valve Tube Seats.
Product ReviewsWrite a review
Will these seats work on the slave cylinder also? The 1967 Mustang Shop Service manual recommends replacing them if signs of wear is apparent. If these seats won't work, then what is the part number for the slave cylinder seats? Thanks for any answers
Hi how do I remove the old control valve seats?
You Might Also Like
/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$459.99
/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$16.99