Scott Drake 1" Rear Lowering Kit for 1967-1970 Mustangs.Don?t heat your springs or remove leafs. Now its easier and safer to lower the rear end. This kit includes cast aluminum lowering blocks and u-bolts with nylock nuts. This kit was specially designed for the Mustang.
Product ReviewsWrite a review
Scott Drake 1" Rear Lowering Kit 1967-1970 is rated out of 5 by 2.
Rated 5 out of 5 by FalconGTHO from Fits like a charm! Installation took about 40mins. Basic tools and common sense goes a long way. Rear lowered 1" and u-bolts long enough to install a 2" block(must buy seperately).
Date published: 2016-02-02
Rated 5 out of 5 by MNichols from simple and easy Easily one of the simplest mods I done it only took about 40 minutes to put on and the cars sits perfect now
Date published: 2015-01-08
Do this lowering blocks fit the ford 9 inch rear axel?
Yes, this will fit.
Date published: 2015-11-22
Will these parts work on a Ford Maverick?
It's possible. However, unless the Maverick is listed as an alternative fitment on a part, we can't say for sure whether it will or won't work, since neither us nor the manufacturer have tested it.
Date published: 2015-03-30
What is the axle and bolt diameter of the u-bolt?
You Might Also Like
CJ's Low Price:$5,049.99
CJ's Low Price:$3,699.99
CJ's Low Price:$5,512.99
CJ's Low Price:$7,299.99
By Bill Tumas: We're here with a one-inch lowering block kit, fitting all 1967 through 1973 Mustangs. The kit includes a set of four new U-bolts, matching U- nuts, and these two billet plates which will lower your '67 through '73 Mustang equipped with stock springs approximately one inch. Our lowering block kit is an inexpensive way to lower the rear end of your '67 through '73 Mustang.