1" Rear-End Lowering Kit Mustang 67-70

The most commonly performed suspension mod on a Mustang is lowering it to give it a more intimidating, aggressive look. Lowering the rear-suspension of your classic, 1967-1970 Mustang doesn’t have to be expensive or difficult. You can easily lower the rear-end of your pony car yourself, DIY-style with this 1-Inch Rear-End Lowering Kit for your 1967-1970 Mustang from CJ Pony Parts. Skip the pricey mechanic and order your own kit today!

Kit Includes:
- (2) Die-cast aluminum lowering blocks
- (4) U-Bolts
- (8)-Piece set of nyloc nuts

Features and Benefits:
- Lowers the rear-end by approx. 1”
- Lowering blocks made from die-cast billet aluminum
- Useable with stock leaf springs
- Works for all 1967-1970 Mustangs
- Inexpensive DIY
- Sold as a complete kit for your convenience
- Direct-fit replacements, easy installation
- Instructions provided

This inexpensive, do-it-yourself kit works to lower the rear-end of your 1967-1970 Mustang by approximately 1 inch. This convenient, 1-inch rear-end lowering kit includes (2) die-cast, billet aluminum lowering blocks; (4) U-Bolts and an 8-piece set of nyloc nuts. When installing this kit, you can use the stock leaf springs, which came factory with your classic pony car. These direct-fit replacement pieces are easily installed on any 1967-1970 Mustang and include comprehensive, easy-to-follow installation instructions.

The suspension in your 1967-1970 Mustang has an important job to perform. Vehicle suspension engineering and design has come a long way since 1967-1970. Therefore, there are plenty of great options available for upgrading your old and worn out suspension. If you’re looking to simply tighten up or repair your suspension, a few easy bolt-on options will add up to create an overall suspension improvement.

Order a 1-Inch Rear-End Lowering Kit for your 1967, 1968, 1969 or 1970 Mustang from CJ Pony Parts today!