Scott Drake Hood To Cowl Seal 1965-1966

Scott Drake: C5ZZ-16740-A

Regular Price: $9.99

Special Price: $8.99

1419379200 40480
Earn 9 RPM Points What's this?
1418947200 1420070400
On Sale: End of Year Blowout!
WSHC11
WSHC11 WSHC11_1 WSHC11_2 WSHC11_3 Play Scott Drake Hood To Cowl Seal 1965-1966 Video 1 Play Scott Drake Hood To Cowl Seal 1965-1966 Video 3

Product Description

Scott Drake Hood To Cowl Seal for all 1965-1966 Mustangs.

Eliminate water and debris from getting in to the engine bay with a new hood to cowl seal from Scott Drake. This seal extends the length of the backside of the hood, where it meets and attaches to the cowl.

Scott Drake's hood to cowl seals are designed to original specifications for a precise fit. Each one features perfect detail right down to the fasteners that are installed with pre-punched retainer holes.

Similar Mustang Parts

similar mustang parts More Mustang Fastback Weatherstrip  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Perfect Fit
A perfect fit on my 66 Mustang and only took minutes to install. The old screws were stripped and difficult to remove so I replaced with new ones.
Dianne October 11, 2014
Looks Great
Fits like a glove. 5 minute install. Little things like this pop out when you raise the hood. Tops off a new paint job.
Crickett 64.5 September 17, 2014
Good fit
Fit perfectly and installed in minutes. Longest part was getting the old clips, the only thing left from the previous weatherstrip, off.
Tony August 25, 2014
Easy swap, fit was excellent
Easy swap to replace the old hood seal for this new one. The fit of the new one matched well.
FRED June 29, 2014
huh!
i dont see the need for this but my car had empty holes where this goes so i bought it. it went in easy
RAH April 12, 2014
5 Results

You Might Also Like

Product Video

By Bill Tumas: In today's quick fix, we're going to show you how to replace the hood to cowl seal found in your '64 through '66 Mustang, using this new piece here from Scott Drake. The hood to cowl seal is going to mount to your cowl. The top edge here is going to touch your hood when you close your hood. It's going to keep debris and water out of the back of your engine bay.

The hood to cowl seal is mounted right here on the front of your cowl. It attaches using Phillips head screws and then clips across the middle. You're going to reuse the screws, and the Scott Drake weather strip actually comes with new clips. We're going to start by removing the ends.

You can see our original hood to cowl seal is all dry-rotted. It's actually been painted as well, so it's falling off. We're going to pull off the brackets on the end first. You'll want to separate this little bracket from the weather stripping. Actually the old weather strip is all cleaned off, so you could install this on the new weather strip. Our original weather stripping is breaking free of all the clips. We'll pull the weather strip off first and then we'll go back and remove all the clips.

We can use a small flathead screwdriver to remove the clips. We'll start the install by laying it across the cowl. I'll pop the clips into place first. Now we'll install the ends with the bracket and the screws, and your installation is finished. In only a few minutes time with a flathead screwdriver and a small Phillips head, the hood to cowl seal is a simple to install part that can prevent costly repairs down the road.