American Car Craft Exterior Mirror Emblem Brushed Stainless Steel Set F-150 Raptor 2010-2013
Highlights
- Officially Licensed Product
- Stainless Steel Construction
- Sold As A 4-Piece Set
- Made In The USA
Set of American Car Craft Brushed Stainless Steel Exterior Mirror Emblems for 2010, 2011, 2012 and 2013 Raptor F-150s.
Add some custom styling to your 2010-2013 Raptor F-150 with this Set of 772013 American Car Craft Brushed Stainless Steel Exterior Mirror Emblems. Made from premium stainless steel and featuring a laser-etched Raptor logo, these trim pieces will make your truck look unique.
Features and Benefits:
- Constructed from 100% stainless steel
- Brushed finish
- Laser-etched Raptor logo
- Sold as a four piece set
- Completes your driver and passenger side mirrors
- Gives your truck a unique look
- Won't rust, tarnish or fade
- Easy peel and stick installation
- Officially licensed by Ford
- Made in the USA
These mirror emblems are sold as a set of four to complete your driver and passenger side exterior mirrors. They are manufactured in the USA from premium stainless steel and given a brushed finish that won't fade, rust or tarnish. The Ford-licensed Raptor logo is then etched into the trim pieces with a laser. Installation is easy. You simply peel off the backing and stick the adhesive onto your side view mirrors to give your truck a one-of-a-kind look.
California Residents: Proposition 65 Warning
Related Categories: Ford F-150 Raptor Parts, Ford F-150 Parts, F-150 Body & Appearance, F-150 Raptor Body & Appearance
Installation Videos
Video Transcript
The emblems are going to mount right here, it's actually a two piece. One here and then a finish off trim piece here. Now we got to make sure that the surface is as clean as possible for installation because this part of the truck is going to be dirty no matter what. We're going to start with some soapy water, then use alcohol and then finally primer.
A little rubbing alcohol. Now I'll grab the supplied primer, what you'll want to do, break it in the middle, you'll hear a crack, then shake it up. Finally our adhesion promoter. They are side specific so make sure you grab the correct pieces. The driver's side is easy to tell, this piece here is actually a lot smaller on the driver's side. Peel back the double stick tape, goes all the way over against the reflector. Now install the secondary piece, line it up with it. Repeat the process on the other side and your installation is finished.
The Raptor logos on the mirrors add a small but subtle touch and as you can see, the mirrors will operate as it normally would as well. Installation again, very, very simple, just clean the mirror thoroughly, but it's a five minute install and be back on the road in no time.
