Cap And Cover Kit Chrome Billet Aluminum With Carbon Fiber Inserts Mustang V6/GT 2015-2017
Highlights
- Billet Aluminum Construction
- Direct Fit
- Carbon Fiber Inserts
- Chrome Plated Finish
Chrome Billet Aluminum Cap and Cover Kit with Carbon Fiber Inserts for 2015, 2016 and 2017 V6 and GT Mustangs.
If you're looking for some high-quality finishing touches to spruce up your 2015-2017 V6 or GT Mustang's engine bay, check out this Chrome Billet Aluminum Cap and Cover Kit with Carbon Fiber Inserts that's now available at CJ Pony Parts!
Features and Benefits:
- Chrome Billet Aluminum
- Includes (4) Billet Cap Covers
- Carbon Fiber Inserts
- Straightforward Installation
This Chrome Billet Aluminum Cap and Cover Kit comes with four (4) chromed billet cap covers that are designed to hide the plastic caps inside your engine bay, making for a nicer and neater appearance when you lift your Mustang's hood to show it off. Each cap includes adhesive backed carbon fiber inserts that you can use if you want or you can leave the chrome in place: your choice!
This Kit Includes:
- One (1) Replacement Oil Cap
- One (1) Windscreen Washer Fluid Cap Cover
- One (1) Brake Reservoir Cap Cover
- One (1) Coolant Overflow Tank Cap Cover
*The cap covers will require the use of double sided tape or silicone adhesive for installation (NOT Included).
*The Replacement Oil Cap that is provided will require the use of the O-Ring found on your Factory Oil Cap.
Please Note: This kit does NOT fit 2015-2017 Ecoboost Mustangs.
California Residents: Proposition 65 Warning
Related Categories: Mustang Parts, Mustang Engine, Mustang Engine Bay Dress-Up
Installation Videos
Video Transcript
What you're going to do there is you put a cap in place, peel back the backing from the carbon fiber, then put it on the edge and press it on. This little washer again just pops in place, install the decal, master cylinder the same way, press it on. The wheel cap's a little different. What you're going to need to do is get a small pick to remove this O-ring from the factory cap and transfer it over to the groove on the new cap. Then you take it and just twist it on until it locks and install your decal. That's all there is to it.
