Master Engine Fastener Kit Mustang 351C 4V 1970-1971

Properly reassemble all your engine components with this master engine fastener kit! Most of the fasteners are either detailed reproductions or new old stock. Plus, each package is thoroughly labeled so know exactly where it goes on your engine. Perfect for 1970-1971 Mustangs with a 351C 4V engine.

Features and Benefits:
- Fits all 1970-1971 Mustangs with a 351C 4-barrel engine
- Factory-correct, OE-style fastener kit
- Comprised of 131 pieces total
- Thoroughly labeled to expedite installation

Kit Includes:
- (1) stamped wing nut for air cleaner
- (1) hex MS screw/conical spring washer assembly for air cleaner heat shroud
- (2) hex washer head screws for air cleaner snorkel
- (8) studs and 7/16" nuts for carburetor
- (4) hex place bolts for crank pulleys
- (1 each) hex bolt and flat washer for crankshaft damper
- (1) hex screw/split washer assembly for distributor
- (3) slot pan head machine screws for distributor points and condenser single
- (2) slot pan head screws for distributor vacuum unit
- (2) external hex pipe plugs for engine block drain plugs
- (8) 3-1/4" bolts and split washers for engine fan
- (4) engine lift hooks for jam nuts
- (16) special "Ramp-Lok" hex screw/conical spring washer assembly for exhaust manifolds
- (3 each) hex screw/split washer assembly, stud, and serrated flange nut for fuel pump
- (3 each) hex screw/split washer assembly, hex washer head screw, hex nut for ignition coil strap and bracket
- (12) flange bolts for intake manifold
- (22) special hex screws and split washer assemblies for oil pan
- (2) hex washer head screw/split washer assembly for starter
- (3) flange bolts for timing cover
- (16) special hex screw/split washer assembly for steel valve covers
- (2) hex screw/split washer assembly for water neck
- (11) hex screw/split washer assemblies, flange bolts, and screws for water pump

Please Note: Does NOT work with 1971 Boss 351 engines.