Ignition Switch Bezel Tool Mustang 1967-1968

Are you trying to remove or install an ignition bezel on your 1967-1968 Mustang? If so, then you probably already know that trying to use a screwdriver or a pair of pliers will only result in a scratched or damaged bezel. Fortunately, CJ Classics makes this ignition switch bezel tool that's specifically made to help you easily take out or put in an ignition bezel!

Features & Benefits:
- Made of Solid Billet Aluminum with an Anodized Finish
- Designed to Help Remove and Install 1967-1968 Ignition Bezels
- Keeps Your Ignition Bezel from Getting Scratched or Damaged
- Allows for the Use of a 7/8" or 22mm Wrench if Needed

This ignition switch bezel tool is made of solid billet aluminum with an anodized finish. It's specifically designed to help you remove and install an ignition bezel on your 1967-1968 Mustang. It even lets you use a 7/8" or 22mm wrench if you need one!

*Do not over-tighten when using this tool. It could damage the bezel and tool. Just use firm pressure when pushing this tool into the bezel when you're loosening or tightening the wrench. Hand tightening should be sufficient in most cases.

**Representative image shown. Part color/finish may vary.