Power Window Kit With Black Console Mount Switches Mustang Coupe/ Convertible 1967-1968

Add the modern luxury of power windows to your 1967-1968 Coupe or Convertible Mustang with this Power Window Kit! This model-specific kit comes with everything you need to convert from those tiring manual crank windows to modern push-button power windows. The kit comes with new power regulators featuring AC Delco motors for the front windows and rear quarter windows, black illuminated double button switches that can be mounted to your console or dash, complete and labeled wiring harnesses, as well as a conduit to protect the wires traveling through the doors.

Features and Benefits:
- Made in the USA
- Converts Manual Crank Windows to Power Operation
- AC Delco Motors
- Black Illuminated Double Button Switches
- Conduit Protected Wiring Harnesses
- Bolt-On Installation

The new power window regulators are designed to bolt directly into the original mounting holes with little to no modifications and will use the original glass channels. You can count on these new power window regulators to last because they are built right here in the USA. Constructed from 1018 cold roll steel with bronze Oilite thrust bearings at all the pivot points and feature treated gear plates for longer teeth life. Each window regulator is equipped with a new AC Delco OEM motor, ensuring the highest quality and performance every time you hit the switch.

Kit Includes:
- New Power Regulators (4)
- New AC Delco Power Window Motors (4)
- Black Illuminated Double Button Switches (2)
- Complete and Labeled Wiring Harnesses (2)
- Conduit (2)

The included switches in this kit are intended for mounting to the console or dash, but can be mounted anywhere you desire. Each switch features a double button setup that will control two windows. The switches are black with white markings and can be illuminated with the correct wiring configuration. With complete and labeled wiring harnesses already attached to the switches, installation is as simple as finding a location to mount the switches, running the wires and you're ready to go!

The wiring harnesses come with all the wires labeled for correct positioning and is fused to allow operation of the power windows without the engine running. The black wire is the ground and should be attached to clean metal to ensure a proper ground. The red (orange) wire is the 12V hot feed.

Please Note: We recommend using the crank handle style switches so you are not left with a hole in your door panels where the factory regulator would come through.