Trigger Accessory Control System DIN Connector Harness
Highlights
- Din Connector Harness
- Allows Manual Control
- For Standard Rocker Switches
- Will Wire Into The Cab
Trigger Accessory Control System DIN Connector Harness.
Use the built-in DIN connector on the Trigger Six Shooter and connect this Trigger (3012) Accessory Control System DIN Connector Harness to get manual control of your conventional rocker switches. Normally, Trigger systems don’t need any wiring into the cab of your vehicle, but this option DIN harness will.
This Trigger Accessory Control System DIN Connector Harness is an all-in-one cable that attaches to the back of the Trigger Six Shooter so you can use a hard-wired switch with the Trigger Controller.
Please Note: Disconnect all power to the Trigger Accessory Controller System before installing the DIN cable so you don’t damage your system.
Are you hoping to make your JK Jeep Wrangler or pickup truck more technologically sound? If so, it would be wise to invest in a new Accessory Control System or Accessory Control components from Trigger. Trigger Accessory Control Systems allow you to add more accessories to your off-road vehicle in the most efficient manner possible.
Order a Trigger (3012) Accessory Control System DIN Connector Harness from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Vehicle Fitment
This product will fit the following Bronco years:
This product will fit the following F-150 years:
This product will fit the following Gladiator years:
- 2020,
- 2021,
- 2022,
This product will fit the following Ranger years:
- 2019,
- 2020,
- 2021,
- 2022,
This product will fit the following Super Duty years:
- 1999,
- 2000,
- 2001,
- 2002,
- 2003,
- 2004,
- 2005,
- 2006,
- 2007,
- 2008,
- 2009,
- 2010,
- 2011,
- 2012,
- 2013,
- 2014,
- 2015,
- 2016,
- 2017,
- 2018,
- 2019,
- 2020,
- 2021,
- 2022,
This product will fit the following Wrangler years:
