Dual Exhaust Kit 2" With Flowmaster Mufflers 260/289/302 1964-1970

CJ's Part Number: EXK3AF
MSRP: $500.75
CJ's Low Price:
$434.99
1418774400 13156
Earn 434 RPM Points What's this?
EXK3AF

Product Description

2" Dual Exhaust Kit for all 1964-1970 Mustangs with a small block Ford engine*.

Small block Ford refers to 260/289 and 302 engines.

Kit Includes:
-H-Pipe
-Driver Side Intermediate pipe
-Passenger Side Intermediate Pipe
-Driver Side Tailpipe
-Passenger Side Tailpipe
-Exhaust Donuts
-Two Flowmaster Mufflers
-Dual Exhaust Muffler Hangers
-Eight 2" Clamps

Similar Mustang Parts

similar mustang parts More Mustang Dual Exhaust Kits  

Installation Instructions

Difficulty

Difficulty: Moderate

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Good value
The exhaust is well made, the bends are all correct and good quality steel.
As per the other review, it was necessary to trim the intermediate pipe and the front of the tail pipe.
Have to remove about an inch and a half to two inches in total. This is necessary because otherwise the part of the tail pipe that goes over the rear axle comes into contact with the underside of the trunk floor, behind the axle.
Better too long than too short. Despite this annoyance I would buy again since its good value.
Frederik July 1, 2014
Dual Exhaust
Its good for the price, but be prepared to do a lot of tweaking to get it to fit nicely. I had to trim the intermediate pipes and tail pipes because the mufflers were too far back and the tail pipes would have been in constant contact with the body.
Rob Henry March 24, 2012
2 Results