Led Taillight Assembly Each 1964-1966

CJ's Part Number: TLLED12
CJ's Low Price:
1418860800 32524
Earn 44 RPM Points What's this?
1418947200 1420070400
On Sale: End of Year Blowout!

Product Description

This LED tailight assembly for your 1964-1966 mustang will really make your car stand out.


- 68 Super Bright LED's
- Polycarbonate High Temperature Lens
- Uses factory style 1157 plug
- Fully Sealed Electronics

Note: Sold each, a car requires two.

When using LEDs, your stock flasher mechanism cannot engage properly, due to less heat given off from the LEDs than original bulbs. HW2811 is a two terminal flasher that allows your flashers/turn signals to work properly when using LED style lights.

Similar Mustang Parts

similar mustang parts More Mustang Taillights  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Great LEDs
These tail lights look good and have the brightness seen on newer cars (or brighter). The installation was super easy and the fit is oem-like. Some reviewers stated that they were able to use them without a new flasher but I had to install the LED flasher to get the turn signals to work. Not a big deal and well worth the extra few minutes to install a new flasher.
Rob November 16, 2014
Great Product
Great product again. I got it on sale,this was the best deal on the internet.
Ken Norris October 30, 2014
SUPER Bright
I was very excited to find these lights. The OEM parts are so (horribly) dim that I worried I was going to get rear ended. These lights are crazy bright, almost to the point of being too bright. To those of you who are looking to improve your safety, with a well built product product, here is your answer. Also, I know that the part description describes a LED flasher as being required. I personally did not need one on my install. I don't know if that will be the same for everyone else but for my install it was plug and play. Install time: 10 minutes (which included drinking a beer!)
Cameron October 27, 2014
Bright but needs 1 detail
This light is bright and of course easy to install, just plug and play. But I wish it came with the FoMoCo plastic lens. I know ultimately it doesn't matter when you go restomod, but it would be a nice detail to add. I had an LED light before, but water got in the housing and ruined it, so I replaced it with this one and hopefully got my water leak fixed!
Ronnie July 28, 2014
Now finally, I'm not concerned if the car behind me can see my brake lights, this is my second set I had a set in my 65 convertible just put a set in my 65 Fastback I've told all my Mustang friends about them it's a must have in my book!
Mark Black July 13, 2014
Finally, tail lights that are visible in day light!
N.J. Dark Horse June 9, 2014
Extra safety!!
Superbright. You can see them in daylight too, everything is sealed in the lens, you don't even need the taillite housing with this lens (except for hooking up the wiring connector). This is cheap safety.
Jan May 25, 2013
Super Bright
Just received these and installed them yesterday. Wow! What a difference in the brightness of these LED lights. Keep the stock look but provide much more light than the original set up.
66StangTexas May 7, 2013
These are great, bright and good looking
Mike September 20, 2012
Too easy and look great!
Like all the other reviews, super easy to install and a lot brighter than the old bulbs yet still keeps the classic look!
Freeman June 4, 2012
13 Results
1 2 >

You Might Also Like