Mustang Universal Parking Light Assembly (1967-1968) Installation Instructions

• 
• 
• 
• 

1967-1968 Mustang Universal Parking Light Assembly

This Universal Parking Light Assembly will fit 1967-1968 Mustangs.

After so many years, many of the lights on your 1967-1968 Mustang can be damaged or worn and require replacement. This Universal Parking Light Assembly fits on either side of your Mustang and gives you nearly every part you need in one package to upgrade. Comes with a housing, clear lens, lens gasket, orange bulb and wiring with plug.

This Install Also Applies To:

• Mustang Scott Drake Parking Light Assembly 1967-1968
• Mustang Parking Light Bezels 1967-1968
• Mustang Parking Light Retainer Pair 1967-1968
• Mustang Parking Light Kit 1967-1968
• Mustang Back Up/Parking Light Nut Set 1965-1970

Tools Required:

• 3/8" Socket and Ratchet

Install Difficulty:

• 
• Easy Project

1. To starting installing your new Mustang Parking Light Assembly, remove one of the original assemblies. There are two bolts that hold the lighting assembly to a retainer bracket on the inside of the fender well.

2. If you're replacing more than just the parking light assembly, now is the time to prepare the new retainer and bezel. As part of that, the Mustang parking light bezel is typically painted prior to installation.

3. Hold the Mustang parking light retainer behind the front valence with one hand and feed the wiring through with the other.

4. The next step to install the new Mustang parking light is to place the bezel on the front side of the valence’s opening and align the holes.

5. Push the lighting assembly through while making sure the studs on the back goes through the aligned holes in the bezel and retainer.

6. Tighten the Mustang parking light nuts on the back side with a 3/8” socket then connect the wire pigtail.

7. Repeat for the other side and enjoy your new Mustang Parking Light Assembly!