Scott Drake Lower Control Arm Assembly Premium Black 1965-1966

Scott Drake: C4DZ-3078-AR
CJ's Low Price:
$68.99
Ships in 5-7 Days This item typically ships within 5-7 days1411084800
Earn 68 RPM Points What's this?
LCA70
LCA70 Play Scott Drake Lower Control Arm Assembly Premium Black 1965-1966 Video 1 Play Scott Drake Lower Control Arm Assembly Premium Black 1965-1966 Video 3

Product Description

Scott Drake Premium Black Lower Control Arm Assembly for 1965-1966 Mustangs.

These lower control arms are the finest available. They feature the original riveted design for a more authentic look. Painted black. Sold each. Car requires two.

Includes:
-Ball joint
-Pressed-in bushing
-Grease seal
-Zerk fitting
-Washer & nut
-Cotter key

OTHER APPLICATIONS
1962-1965 Mercury Comets
1962-1965 Ford Falcons

Similar Mustang Parts

similar mustang parts More Mustang Front Lower Control Arms  

Installation Instructions

Difficulty

Difficulty: Moderate

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review

Product Video

By Bill Tumas: Of the thousands of products we currently carry here at CJ's, the manufacturer customers usually ask for by name most is Scott Drake.

For over 30 years Scott Drake has produced high-quality Ford-licensed restoration parts for your Mustang.

Starting off with the Trunk Weatherstrip he made while still in high school for a shop teacher, today Scott Drake offers over 9,000 products making them the largest manufacturer of Mustang restoration parts around.

Currently based in Henderson, Nevada, just outside of Las Vegas, Scott Drake is expanding his restoration line to include late model Mustang parts under the Drake Muscle Cars name.

Today let's take a closer look at some of their products and the attention to detail Scott Drake puts into them.

This is replacement lower control arm for your '64 through '66 Mustang. The lower control arm is an integral part of your front suspension, so you want to make sure you have a quality product. You can immediately see that Scott Drake has a much nicer finish, and also has the correct black and gray two-tone finish as well. The biggest difference is going to be in the ball joints, starting with the Castle nut. Scott Drake uses a much heavier duty hardware than our standard reproduction. You can see it's almost twice the thickness. It's going to be a lot stronger when threaded on. Removing these, the cover for the boots is a nice heavy plastic cover for the Scott Drake, very thin plastic flimsy cover on the standard reproduction piece.

Now we pull these off so you can see the boots themselves. Again, much higher quality thick rubber boot on the Scott Drake, much thinner quality on the standard piece. Once you flip them over, you can see that Scott Drake has the correct style rivets. It's also greaseable, where your standard reproduction is not. Again, it's going to make the product last a lot longer. You can see the difference with the two-piece heavy duty bracket as well as the tabs on here. They're edge welded on this piece here. These are installed with the correct spot welds.

If you're looking for the best fitting, highest quality parts for either your restoration or your late model Mustang make sure you check our selection of Scott Drake products.