CJ Classics Inner Tie Rod End Manual Steering 6-Cylinder 1965-1966

Does your 1965-1966 Mustang pull to one side while driving or when braking? Maybe hear a knocking noise while turning at low speeds? These are some signs of your inner tie rods going bad. The inner tie rod ends go bad due to bad road conditions or just wear out with time.

This inner tie rod end is a direct replacement for the 1965-1966 Mustang with a 6-cylinder engine and manual steering. This inner tie rod end will work on either the driver side or passenger side of your Mustang. The inner tie rod end is grease able which helps when doing routine maintenance to the steering components.

Features:
- Fits 1965-1966 Mustangs
- Works on Driver or Passenger Side
- OEM Style Replacement
- Mounting Hardware Included
- Grease Able Inner Tie Rod End

Tech Tip: CJ Pony Parts recommends that you replace both inner tie rods at the same time.

Steering your Mustang might be something you take for granted, especially if you have a newer Mustang, in early model Mustangs, the steering is often manual and prone to breaking. Therefore, CJ Pony Parts offers hundreds of steering parts to allow all owners to upgrade their ponies to power steering, or repair virtually anything that might go wrong with their classic manual steering system.

Purchase a new Inner Tie Rod End for your 1965-1966 6-Cylinder Mustang with Manual Steering from CJ Pony Parts today!