Mishimoto Oil Cooler Kit With Thermostatic Sandwich Plate Silver Mustang GT 2015-2017

High oil temperatures are no good when you're trying to enjoy the drive or cut a fast lap time. These Mishimoto Oil Coolers (MMOC-MUS8-15T) will replace your stock oil cooler with a beefed-up bar-and-plate design, that allows more room for power adders while increasing thermal efficiency. These kits allow the maximum amount of air through the cooler for peak performance.

Features and Benefits:
- Innovative Bar-And-Plate Oil Cooler Mounts in the Upper Grille
- Allows More Room for Supercharger Heat Exchangers
- Fits with Most Aftermarket Supercharger Kits
- Mounting Bracket Also Serves as An Air Diversion Panel
- Directs the Maximum Amount of Ambient Air Through the Oil Cooler
- Pre-Made Stainless Steel Braided Oil Lines with Durable -AN Fittings
- Comes With a Replacement Lower Radiator Hose to Bypass the Stock Fluid-Based Oil Cooler
- Removes The Stock Fluid-Based Oil Cooler for Less Stress on The Engine's Cooling System
- Billet Aluminum Thermostatic Oil Sandwich Plate

Thanks to the revised design from Mishimoto engineers, this heat exchanger is the largest profile available and mounts where it receives the most amount of airflow. Braided stainless lines transfer oil from the cooler to the engine, and feature -10AN fittings for simple installation.

Vehicle Fitment:
- 2015-2017 GT Mustangs
- NOT for use Right-Hand-Drive (RHD) models.

This Kit Includes:
- (1) Application Specific Mounting Bracket / Air Diversion Shield
 (1) Bar and Plate Oil Cooler
- (1) 2ft 5in Stainless Steel Braided Hose w/ -10AN Fittings
- (1) 4ft 11in Stainless Steel Braided Hose w/ -10AN Fittings
- (1) M22 Thermostatic Sandwich Plate
- (1) Application - Specific, M22 x 1.5 Extended Length Center Bolt
- (2) M20 x -10AN Straight Fittings
- (2) 1/8" NPT Plugs
- (1) Large O-ring
- (1) Lower Radiator Hose w/ Worm Gear Clamps
- (1) Mounting Hardware Set

Please Note: Mishimoto Fully Inspects and Cleans All Products Prior To Packaging. However, It Is Recommended That Customers Flush the Oil Cooler with One Quart of Clean Oil Prior To Installation to Remove Any Debris Accumulated During Shipping.

Tech Tip: Requires the Removal of The Stock Coolant-Based Oil Cooler. Recommended Torque Specification for All Straight Fittings and Banjo Bolts: 15-25 Ft/Lbs. Do Not Exceed the Maximum Torque Rating Of 35 Ft/Lbs.