Painless Performance Truck Harness 25 Circuit Pro Series For Key In Column

Painless Performance:
10415
MSRP $668.57
$604.99
You save 10%
Earn
points.
Product Description

Painless Performance 25-Circuit Pro Series Truck Harness for a Key-in-Column Set-Up.

If it’s time to rewire your vintage 1960 and you need ample length to ensure you can do it just the way you want to, be sure to order this Painless Performance (10415) 25-Circuit Pro Series Truck Harness from CJ Pony Parts! 

Features & Benefits:
- Gives You Everything You Need to Wire Up Your Pro-Touring or Custom Ride Right the First Time
- Ample Length (Extra Length of Up to 20' to Front and Over 25' to Rear) Provided for Each Circuit to Give You Freedom to Route and Hide Your Wiring How You Choose
- Includes Over 25 GM Factory-Style Connectors Found on Most ‘60s to Early ‘90s GM Switches: Allows You to Turn Pro Series Harness into Direct Fit Harness
- LED ATC Bladed Fuses Replace Old, Hard-to-Find Glasses Fuses and Light Up if Blown to Make Troubleshooting Easier
- 6-Gauge Charge Wire and Midi Fuse (No More Problematic Fusible Link) Keep Up with Today’s High Amperage Alternators
- Included Front and Rear Ground Harnesses Make Grounding Lighting Circuits Easy
- Includes Many GM Connectors and Terminal, Insulated and Non-Insulated Butt Splices, Heat Shrink, Grommets, Cable Ties, Ground Straps and Cable Tie Clips
- GM Bulkhead-Style Firewall Pass-Through with Fuse Block Mounted Inside Vehicle on Firewall: Exact Same Connector GM Used on Many 1968+ Vehicles
- Wires are Pre-Terminated Using Packard Factory Crimping Machines and Use Bulkhead to Mount to and Pass Through Firewall to Keep Wiring Safe and Protected Plus Allows You to Easily Disconnect Firewall-Forward Wiring without Having to Removing Wiring from Each Individual Component
- After Trimming to Fit, Use Provided Terminals and Connectors to Terminate Ends
- Includes Pre-Terminated GM Column-Mounted Ignition Switch Connector to Allow You to Simply Plug into GM Keyed and Many Aftermarket Columns that Use GM Keyed Ignition Switch 

This Painless Performance (10415) 25-Circuit Pro Series Truck Harness gives you everything you need to wire up your pro-touring or custom ride right the first time! This harness has plenty of length for each circuit so you can route and hide your wiring however you choose. It features LED ATC bladed fuses to replace your old and hard-to-find glasses fuses, and they even light up if they’re blown to make troubleshooting even easier! 

Includes:
- Four (4) H4 Headlight Connectors: Supports Single (High/Low) or Dual Headlights (Separate High Beams)
- Two (2) Turn Signal Connectors: Fits Connectors Found on Factory GM Hard Wired Turn Signals
- Four (4) Molded ¼ Sockets for Front and Rear Marker Lights
- Two (2) HEI Distributor Connectors (+ and Tach)
- Two (2) Connectors for Factory GM Wiper Motor
- GM Washer Pump Connector
- Courtesy Light Sockets
- GM Headlight Switch Connector
- GM Dimmer Switch Connector
- GM Brake Switch Connector
- GM Turn Signal Switch Flat Connectors (Early and Late)
- GM Ignition Switch Connectors*
- Neutral Safety Switch Connector (Column-Mounted or Factory Floor Shifter-Mounted)
- Reverse Switch Connector (Column-Mounted or Factory Floor Shifter-Mounted)
- Braided Ground Straps (for Body and Core Support to Frame Grounding. Also Includes Six (6) Self-Tapping 1/4" Screws for Mounting)
- Alternator Bag Kit with Terminals, Splices, Resistor, Diode to Connect the Alternator and One (1) Connector for GM 10si Alternator
- Assortment of Insulated and Non-Insulated Splices, Ring Terminals, Heat Shrink, Grommets, Cable Ties and Cable Tie Clips 

Includes Circuits For:
- A/C and Heat
- Accessory (Fan Relay Activation, etc.)
- Backup Lights
- Brake Lights
- Charging
- Cigarette Lighter
- Dome / Courtesy Lights
- Electric Choke
- Electric Fuel Pump
- Emergency Flashers
- Fused Power Source
- Grounds – Front and Rear Lights
- Headlights
- Horn (Relay)
- Ignition Coil
- Instrument Panel Lighting and Gauges*
- Park / Marker Lights
- Power Door Locks
- Power Windows
- Radio / Clock (Constant and Switched)**
- Starting
- Taillights / License Plate Light
- Third Brake Light
- Turn Signals
- Wipers / Washer Pump 

*Includes Wires For:
- Fuel Gauge
- Oil Gauge
- Tachometer
- Temperature Gauge
- Voltmeter 

**Includes Amp Activation Wire

Fitment:
- 1960-1987 Chevrolet C10
- 1948-1979 Ford F-100

California Residents: Proposition 65 Warning

Related Categories: Ford F-100 Parts, F-100 Electrical & Wiring, Chevrolet C10 Parts, F-100 Dome Light Wiring, F-100 Headlight Wiring

Installation & Fitment

Vehicle Fitment

This product will fit the following C10 years:

This product will fit the following F-100 years:

  • 1948,
  • 1949,
  • 1950,
  • 1951,
  • 1952,
  • 1953,
  • 1954,
  • 1955,
  • 1956,
  • 1957,
  • 1958,
  • 1959,
  • 1960,
  • 1961,
  • 1962,
  • 1963,
  • 1964,
  • 1965,
  • 1966,
  • 1967,
  • 1968,
  • 1969,
  • 1970,
  • 1971,
  • 1972,
  • 1973,
  • 1974,
  • 1975,
  • 1976,
  • 1977,
  • 1978,
  • 1979,
Questions & Answers
Only registered users can ask/answer questions. Please sign in or create an account.
Reviews
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account