Power Window Kit With Crank Handle Switches Mustang 1969-1970

CJ's Part Number:
69PWKC
Rating:
95% of 100

Highlights

  • AC Delco Window Motors
  • 2 Crank Style Handle Switches
  • Labeled Wiring Harness
  • New Power Regulators
$757.80

Power Window Kit with Crank Handle Switches for all 1969-1970 Mustangs.

This Power Window Kit with Crank Handle Switches for all 1969-1970 Mustang coupes, convertibles and fastbacks allows you to reuse your original window cranks that will help maintain the factory look you love!

This kit comes with everything you need to convert from those tiring manual crank windows to a custom power window setup with power crank handle switches that reuse your original window crank handles. It includes new power regulators featuring AC Delco motors for the front windows, power crank handle switches for original window cranks, a complete and labeled wiring harness, as well as conduit to protect the wires traveling through the doors.

Kit Includes:
- New Power Regulators (2)
- New AC Delco Power Window Motors (2)
- Power Crank Handle Switches (2)
- Complete and Labeled Wiring Harness (1)
- Conduit (2)

Constructed from 1018 cold roll steel with bronze Oilite thrust bearings at all the pivot points and treated gear plates for longer teeth life. The new power window regulators are designed to bolt directly into the original mounting holes with little to no modifications and will use the original glass channels. Each window regulator is equipped with a new AC Delco OEM motor, ensuring the highest of quality and performance every time you hit the switch.

This kit includes power crank handle switches that are controlled by pushing down on the crank handle to lower the window and pulling up on the crank handle to raise the window. These crank handle switches mount behind the door panels and allow the use of original window crank handles. The original window cranks mount directly on to the new power crank handle switches the same way they would mount on to the factory manual window regulators. The wiring harness comes with all the wires labeled for correct positioning and is fused to allow operation of the power windows without the engine running. The black wire is the ground and should be attached to clean metal to ensure a proper ground. The red (orange) wire is the 12V hot feed.

*Original glue-in style door glass found in 1969 and some 1970 Mustangs may be too weak to handle the new power regulators; it is recommended to replace the old glue with new, stronger glue; or convert to 1970 bolt-in style door glass.

Please Note: We recommend using these crank handle style switches so you are not left with a hole in your door panels where the factory regulator would come through.

California Residents: Proposition 65 Warning

Installation Difficulty

Moderate
Moderate

Intermediate skill is required for this installation.

Vehicle Fitment

This product will fit the following Mustang years:

Only registered users can ask/answer questions. Please sign in or create an account.
Write Your Own Review
Only registered users can write reviews. Please sign in or create an account.