Borgeson Saginaw Power Steering Pump Kit for 1965, 1966, 1967, 1968, 1969 and 1970 Mustangs with a 289, 302 or 351W V8 Engine.
This is a worthwhile upgrade to consider when upgrading your existing power steering to a Borgeson Saginaw Power Steering Pump Kit. Provides better power assist at idle and enhances response and drivability over the Ford pump.
- Saginaw Power Steering Pump
- Saginaw Power Steering Pump Bracket
- Power Steering Pump Pulley
- All Necessary Mounting Hardware
Please Note: If using the stock Ford hoses, you will need a hose adapter, part number HW3409.
You will be able to easily replace your broken, old and tired OE power steering pump with this new Borgeson Saginaw Power Steering Pump Kit. Coming with everything you need, this kit will make the restoration process on your 1965-1970 Mustang a breeze. Installation is simple and straightforward coming with all necessary mounting hardware.
The steering on your classic or late model Mustang contains many vital components for keeping your Mustang on the road. If one of these components should break, or you want to perform an upgrade to add some higher quality insurance for the future, the steering components from Borgeson should be at the top of your list.
Order a Borgeson Saginaw Power Steering Pump Kit for 1965, 1966, 1967, 1968, 1969 and 1970 Mustangs with a 289, 302 or 351W V8 Engine from CJ Pony Parts today!
Product ReviewsWrite a review
What psi pump pressure and gpm?
Will the pump fit a 1966 289 stock A/C car? (clearance to the stock AC compressor)
Can you use the same belt or does it need a longer or shorter one?
I have a complete kit on my 1968 mustang. Do the mounting bolts on the back of the pump reservoir need to be sealed? I'm getting some fluid leakage out of the mounting holes.
So the old power steering pump has a bracket that bolts to the water pump are the bolts too long or is there plenty of room to tighten thoes down with out damaging the timing cover or the block?
I am adding power steering to my 1967 289 mustang. I have already added the power steering ram. control valve, and linkage. To use this pump, are there any additional brackets required to install it on the block ?
Is the pump itself on this kit the same pump that comes with the pspk1 part ?. I ordered the pspk2 but what I need is the pspk1 and rather than return it I am wondering if I could just use the pump and pulley itself ?
will a borgeson power steering conversion kit work on a 351C motor.
You Might Also Like
CJ's Low Price:$1,030.07
CJ's Low Price:$1,001.99
CJ's Low Price:$946.99