Accel Coil Pack Supercoil Blue Set Focus ST 2013-2018/Focus RS 2016-2018
Set of Accel Blue Supercoil Coil Packs for all 2013, 2014, 2015, 2016, 2017 and 2018 Focus STs and 2016, 2017 and 2018 Focus RSs.
Looking to upgrade your 2013-2018 Focus ST or 2016-2018 Focus RS’s ignition system? Then you should take a look at this Set of Accel Blue Supercoil Coil Packs from CJ Pony Parts! These coil packs are a direct replacement for the stock coil packs on your ST or RS and will improve the spark energy of your ignition system.
Accel Supercoil Coil Packs 140670B-4 Features and Benefits:
- Up to 15% Increase in Spark Energy
- Improved Throttle Response
- Shock and Vibration Resistant High-Temperature Vacuum Applied Epoxy
- Maximizes Fuel Mileage
- Direct OEM Replacement
- ODB II Compatible
- Sold as a Set of 4
- Easy Installation
Accel has brought their high-quality high output coil-on-plug Supercoil coil packs to the Focus ST and Focus RS. The Accel Supercoil puts out up to 15% more energy than the stock coils. This increase in energy will improve the throttle response of your ST or RS and maximize its fuel mileage. Optimized windings, resistance and turn ratios increase the efficiency of your engine to provide its maximum horsepower potential. To ensure constant operation the coil packs feature a high-temperature vacuum applied epoxy that is resistant to shock and vibrations. You will receive a set of four coil packs that are ODB II compatible and are a direct OEM replacement for easy installation.
Accel has more than 40 years of experience manufacturing performance ignition systems and components. Over those years, ACCEL has established themselves as one of the industry leaders in ignition products by providing the highest quality and reliable parts in the industry.
Order this Set of Accel 140670B-4 Blue Supercoil Coil Packs for your 2013, 2014, 2015, 2016, 2017 or 2018 Focus ST or 2016, 2017 or 2018 Focus RS from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Only for use on pre-pollution controlled vehicles: This product can be used on vehicles that were manufactured before emissions control regulations were imposed. Pre-pollution vehicles are defined as:
- 1965 and older U.S. manufactured California certified vehicles
- 1967 and older U.S. manufactured federally certified vehicles
These blue ACCEL Super Coils are going to be a direct fit replacement for the factory ignition coils and they're going to increase spark energy by 15% for improved throttle response, fuel economy, and performance. They're sold as a set of four and are shock and vibration resistant and today we're going to be installing them in our 2016 Focus RS.
This is going to be without a doubt the quickest and easiest performance upgrade you can do to your Focus RS, and we're going to start off by removing the engine cover. With a seven millimeter socket, loosen this clamp on the intake hose, and this clamp as well. Loosen this bolt with an eight millimeter socket. Remove this grommet from the intake pipe, and then pop the hose out of this clip back here and then remove the pipe. Remove the plastic clip on the stub on the ignition coil.
Use an eight millimeter socket to remove the stub. Pull this white clip back away from the connector, like that, and then it pulls right off the coil. Pull the original coil out and replace it with your new ACCEL coil. Make sure it's seated properly, plug it back in and reinstall the stud. Put this clip back over it and repeat the process for the other three coils. Using an eight millimeter wrench for this one. This intake tube is a little bit in the way.
Reinstall the intake tube, and tighten up the two hose clamps. Now, you could stop right here. We'll reinstall the engine cover and your installation is finished.
Our blue ACCEL Super Coils are installed. They look really good under the hood. They install without a single issue, installation should take about 10 minutes, and before you know it, you'll be heading down the road.