Edelbrock Throttle Body Pro-Flo XT 90mm Satin For Edelbrock High-Flow Satin Intake Elbow 260/289/302

Do you need a new high-quality throttle body that will fit on your new Edelbrock High-Flow Satin Intake Elbow on your 260, 289 or 302 engine? If so, be sure to pick up this Edelbrock Satin 90mm Pro-Flo XT Throttle Body that’s now available at CJ Pony Parts!

Features & Benefits:
- 90mm Bore
- 1,100 CFM Air Flow Rate
- Made of High-Quality Cast Aluminum with Satin Finish
- Designed for Use with Pro-Flo XT EFI Manifolds and Victor EFI Intake Elbows
- Ideal for High Performance Street, Race and Custom EFI System Installations
- Uses Standard Ford 5.0L Mounting Bolt Pattern
- 4.0" Diameter Inlet Flange
- Comes with Idle Bleed Screw for Better Idle Control
- Bleed Screw Can be Used to Create Base Amount of Idle Air Flow Instead of Using Throttle Tip-In to Leave TPS Signal Unaffected

This Edelbrock (3818) Satin 90mm Pro-Flo XT Throttle Body offers a 1,100 CFM air flow rate and is made of cast aluminum with a nice-looking satin finish. It’s designed for use with Pro-Flo XT EFI Manifolds and Victor EFI Intake Elbows and is ideal for high performance street, race or custom EFIT system installations. It uses a standard Ford 5.0L mounting bolt pattern and comes with an idle bleed screw for better idle control! This bleed screw can be used to create a base amount of idle air flow instead of using throttle tip-in, which leaves the TPS signal unaffected!

Includes:
- 90mm Throttle Body
- Throttle Position Sensor (TPS)
- Throttle Body Gaskets

Please Note: Mounting hardware is not included.

Order an Edelbrock (3818) Satin 90mm Pro-Flo XT Throttle Body for your 260, 289 or 302 Engine Equipped with an Edelbrock High-Flow Satin Intake Elbow from CJ Pony Parts today!