Sequential LED Taillight Assembly Mustang 1965-1966
Highlights
- Tap To View 3D Model
- 68 Bright Red LEDs
- Sequential Taillights
- 1157 Plug Type
Sequential LED Taillight Assembly for all 1965-1966 Mustangs.
LED lights continue to grow in popularity: and with good reason! LEDs are brighter than your factory bulbs, which makes them a better and safer choice than standard bulbs. So if you're looking for a great way to upgrade the taillights on your classic 1965-1966 Mustang, look no further than this Sequential LED Taillight Assembly that's now available from CJ Pony Parts!
Features and Benefits:
- 68 Super-Bright Red LEDs with a Polycarbonate Lens
- Sequential Operation
- Sequential-Once Brake Attention Function
- 1157 Plug
- Solid-State Circuit Board Designed for 7.7-14.0 VDC
- Fits Driver Side or Passenger Side
- Sold Individually
This Sequential LED Taillight Assembly features 68 super-bright red LEDs with a polycarbonate lens. There's also a sequential-once brake attention function. The assembly has an 1157 plug and a solid-state circuit board designed for 7.7-14.0 VDC. It is sold individually and will fit either the driver side or passenger side of your Mustang!
Additional Notes:
- It is recommended that you upgrade to a new under-dash LED flasher. Please see CJ Pony Parts # HW2811.
- If the sequential is going the wrong way, you flip the lens 180 degrees.
California Residents: Proposition 65 Warning
Related Categories: Mustang Taillights, Restomod Lighting, Mustang Sequential Taillights
Installation Difficulty
Novice skill is required for this installation.
Installation Videos
Video Transcript
Because you're converting a sequential, a little bit of wire will be necessary. The plug will plug right into your factory 1157 bulb. The yellow wire will have to be run to the other taillight and then a single wire run up front to your turn signal switch for proper operation.
