Total Control Products Lower Control Arm Eccentric Eliminator Kit 1967-1973
- 3 Hole Design
- 5 Degree Range Of Adjustment
- 11 Offset Positions
- Direct Replacement Hardware
Total Control Products Lower Control Arm Eccentric Eliminator Kit for all 1967, 1968, 1969, 1970, 1971, 1972 and 1973 Mustangs.
On the factory lower control arm on 1967-1973 Mustangs, Ford used an eccentric bolt that would allow you to adjust the camber. However the bolt did little to prevent rotation of the eccentric plate and allows for the mounting position of the lower control arm to change or shift under heavy loads or impacts such as potholes, road debris and off-track excursions. Eliminate the possibility of this occurring on your classic Pony by picking up this Lower Control Arm Eccentric Eliminator Kit from Total Control Products!
The square shape of the eccentric eliminators will keep the plate secure so you won't have to worry about your alignments getting altered. Not only will this kit provide preventive maintenance but it will also produce a nice range to adjust your camber.
Features & Benefits:
- Directly Replaces Factory Hardware
- Keeps Lower Control Arm Locked in Place
- 3-Hole Design
- Manufactured from Laser-Cut 1/4" Steel
- Zinc Plated
- 11-Offset Positions
- 5 Degree Range of Camber Adjustment in Increments of 1/2-Degree
- Grade 8 Mounting Hardware Included
For this specific kit, Total Control Products provides four eccentric eliminator plates in total. The Eccentric Eliminators will directly replace the factory hardware on your 1967-1973 Mustang and will keep your lower control arm locked into places, preventing any probable issues you may run into there. Total Control Parts creates these eccentric eliminators from laser-cut 1/4" steel and then caps it off with a zinc plated finish to prevent any future rusting. Each plate features three 1/2" mounting holes that enable 11-offset mounting positions so you can properly set the suspension camber range and track width you desire. This 3-hole design also allows for the adjustment range up to five degrees in increments of 1/2 degree.
Total Control Products also provide the correct grade 8 mounting hardware in this kit so you can make sure everything is installed correctly.
Mounting Hardware Includes:
- Hex Head Bolts (2)
- Nylon Insert Locknuts (2)
- Washers (4)
*This kit is for use with OEM or TCP lower control arms ONLY.
- Ford Fairlane 1966-1971
- Ford Falcon 1966-1970
- Ford Maverick 1970-1977
- Ford Ranchero 1966-1971
- Ford Torino 1968-1971
- Mercury Comet 1966-1977
- Mercury Cougar 1967-1973
- Mercury Cyclone 1966-1971
- Mercury Montego 1968-1971
Pick up this Total Control Products Lower Control Arm Eccentric Eliminator Kit for your 1967, 1968, 1969, 1970, 1971, 1972 and 1973 Mustang from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Intermediate skill is required for this installation.