Trufiber Hood A45 Heat Extractor Fiberglass Mustang V6/ GT 2005-2009

When it's time to get a new hood for your 2005-2009 Mustang, you could go with another steel hood. Or you could go with a new fiberglass hood from Trufiber, like this one! This fiberglass heat extractor hood will pull hot air away from your engine compartment out of the two open heat extractor vents, which will help keep your engine cool and improve your engine performance.

Features and Benefits:
- Fully Functional Heat Extractor
- Hot Air Exits From Two Open 2003-2004 Cobra-Style Heat Extractor Vents
- Show-Quality Finish, Hand-Laid Fiberglass
- Smooth Gel Coat Finish on Top and Bottom
- For Additional Safety, Metal Latch and Hinge Plate are Reinforced
- Integrated Stainless Mesh Grille
- Hole for Prop Rod is Pre-Drilled
- Direct Bolt-On Using OEM Hardware
- Approximate Weight: 35 Pounds

This Trufiber TF10024-A45 Fiberglass A45 Heat Extractor Hood weighs in at a mere 35 pounds and has a fully functional heat extractor. Hot air will exit from your engine compartment through the 2003-2004 Cobra-style heat extractor vents. Your engine should run cooler and perform better after you install this hood! But this hood doesn't just enhance engine performance. It also offers plenty of aesthetic benefits too! It's made out of hand-laid fiberglass and features a lovely show-quality, smooth gel coat finish on both the top and bottom. It also has an integrated stainless mesh grille as well as a reinforced metal latch and hinge plates for additional safety.

To make this direct bolt-on installation job even easier on you, you can use your OEM hardware and the prop rod hole comes pre-drilled!

Please Note: For safety purposes, hood pins are required for ALL aftermarket hoods.

*This hood will require priming and painting before installation.

Vehicle Fitment:
- 2005-2009 V6 Mustang
- 2005-2009 GT Mustang