Windshield Washer Hose Clip Pair Mustang 1965-1969
Highlights
- For 1965-1969 Mustangs
- Holds Washer Hose in Place
- Sold as a Pair
- Easy Installation
Pair of Windshield Washer Hose Clips for all 1965, 1966, 1967, 1968 and 1969 Mustangs.
Are you installing new windshield washer hoses on your 1965-1969 Mustang? Then you're going to need some new clips to attach them! Take a look at this Pair of Windshield Washer Hose Clips from CJ Pony Parts!
Features and Benefits:
- Sold as a pair
- Routes washer hose to the nozzles
- Direct fit replacement
- Enough for driver and passenger sides
This Pair of Windshield Washer Hose Clips will attach to your Mustang's cowl lip and help route the washer hose to the nozzles. This pair is a direct fit replacement, so you'll get a correct fit when you install them. They are sold as a pair, you'll get two clips with your order. This will be enough for both the driver side and passenger side of your Mustang.
Vehicle Fitment:
- 1965-1969 Mustang
California Residents: Proposition 65 Warning
Related Categories: Mustang Parts, Mustang Engine, Mustang Engine Hardware, Mustang Windshield Washer Systems, Mustang Washer Hardware
Video Transcript
While the rest of our convertible is in really good shape, the cowl is typical of an older Fox Body. We've got some cracks on the edge here. The entire thing is dated. It's time for a new one. The installation is very straightforward; the only tool required is a Phillips head screwdriver.
We're going to start by removing our wipers. We're going to lift up on the arm and pull this little tab out, rest the arm against the tab, and slide the wiper off. Now we'll remove the six screws that hold the grille on: two here, two in the middle, and two on the other side. Once we remove the screws, the grille will just lift straight off. We're going to reach underneath and disconnect the washer nozzle hose. Before you throw your old grille away, you want to make sure you get the washer nozzle off of it. You'll need that for your new grille.
We'll install the nozzle on our new grille, and it's ready to install. Before we install the new grille, we're going to clean up this area and replace these screw retainers as well. Easy way to get these out is to push them through and pull them out from the bottom.
We'll install the new screw retainers, and press down and click them into place. Now we're ready to install the new grille and reconnect the washer nozzle. We're going to tighten these down snug; you don't want to over- tighten them, since you're tightening into plastic. Now the last step is to reinstall our wipers. We'll line them up, tilt them forward again, push the clip down, and release. And our installation's finished.
A few minutes of work made a huge difference on our convertible. Installation should take you no more than about 10 minutes. You'll be back on the road in no time.
