Rear Outside Snap Driveshaft Universal Joint for 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977 and 1978 Mustangs.
If you're servicing the rear axle on your 1965-1978 Mustang, then you should be sure to replace the driveshaft U-joint too. It's a commonly overlooked part, but it's critical that you replace it in order to keep your Mustang safely on the road. So if you're in the market for a new driveshaft U-joint, be sure to check out this Rear Outside Snap Driveshaft Universal Joint from CJ Pony Parts!
This Rear Outside Snap Driveshaft Universal Joint is a direct fit replacement for your original driveshaft U-joint. It comes with a grease fitting for easier servicing and snap rings. This cross-shaped connector has to endure plenty of changes in speed and torque while you're driving, so you need to be sure to replace it when you're repairing or replacing your rear axle. Otherwise, you could wind up with bigger rear axle problems later on down the road!
U-Joint Size and Dimensions:
- Cup Diameter: 2-1/16" and 2-1/8"
- Outside with Locks: 3-7/32"
- 1965-1967: 200 with Automatic Transmission
- 1965-1966: 260/289
- 1967: 289
- 1968-1969: 200 4-Speed Manual Transmission or Automatic Transmission
- 1968-1969: 250/289/302/351
- 1970-1973: with 3-1/2' Yoke Out
- 1974-1978: All
How does your Mustang's transmission feel when you shift gears? If it doesn't seem to be working well, it might be time to consider a new transmission. CJ Pony Parts has these and many other Mustang transmission parts, so you can easily get the parts you need to make your Mustang's transmission function like new again.
Order a Rear Outside Snap Driveshaft Universal Joint for your 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977 or 1978 Mustang from CJ Pony Parts today!
Product ReviewsWrite a review
Is this the replacement for ford part C3AZ-4635-E
Will this work for a 1968 6 cylinder 3 speed transmission?
i need universal joint front rear shaft that is after transmision case for toyota highlander 2003 do u have
Will this work with a '65 289 4-speed manual transmission?
Hi! What is the oem part number of that u joint? mustang 1978 5.0l on differential
Hi, for a 1968 289 C4, does this only fit the rear axle side of the driveshaft ? Or the trans yoke side too ? thanks
do you have U joints not made in china
I have a universal joint stamped F1 N30 22 SPR. Do you have a replacement? Thanks
You Might Also Like
CJ's Low Price:$20.99
CJ's Low Price:$47.99